Bosch PS130 Instrucciones De Funcionamiento Y Seguridad página 14

2610056735 02-21 PS130_BM 2610015935 02-12.qxp 2/15/21 10:23 AM Page 14
or cast iron. If the hole to be drilled is fairly
large, drill a smaller hole first, then enlarge to
the required size, it's often faster in the long
run. Main tain enough pressure to assure that
the bit does not just spin in the hole. This will
dull the bit and greatly shorten its life.
Preventive maintenance performed by un -
au thorized personnel may result in
misplacing of
components which could cause serious
hazard. We recom mend that all tool service
be performed by a Bosch Factory Service
Center or Authorized Bosch Service Station.
SERVICE MEN: Disconnect tool and/or
charger from power source before servicing.
BATTERIES
Be alert for battery packs that are nearing
their end of life. If you notice decreased
tool performance or significantly shorter
running time between charges then it is
time to replace the battery pack. Failure to
do so can cause the tool to operate
improperly or damage the charger.
TOOL LUBRICATION
Your Bosch tool has been properly
lubricated and is ready for use.
Maintenance
To avoid accidents, always disconnect the tool and/or charger from the
power supply before cleaning.
Service
NO USER SERVICEABLE
PARTS INSIDE.
internal wires
RUNNING NUTS AND BOLTS
Variable speed control must be used with
caution for driving nuts and bolts with socket
set attach ments. The technique is to start
slowly, increasing speed as the nut or bolt
runs down. Set the nut or bolt snugly by
slowing the drill to a stop. If this procedure is
not followed, the tool will have a tendency to
torque or twist in your hands when the nut or
bolt seats.
The motor in your tool has been engineered
for many hours of dependable service. To
maintain peak efficiency of the motor, we
recommend it be examined every six
months. Only a genuine Bosch replacement
and
motor specially designed for your tool
should be used.
plastic parts. Some of these are: gasoline,
car bon tetrachloride, chlorinated cleaning
solvents, ammonia and household detergents
that contain ammonia.
Ventilation openings and switch levers must
be kept clean and free of foreign matter. Do
not attempt to clean by inserting pointed
objects through opening.
-14-
D.C. MOTORS
Cleaning
Certain cleaning agents
and solvents damage