Tabla de contenido
Idiomas disponibles
Idiomas disponibles
> Before Start
> Part Names
Rear Panel
1. ANTENNA FM UNBAL 75Ω jack: Connect the supplied antenna.
2. Wireless antenna: Raise for Wi-Fi connection or when using a BLUETOOTH enabled
device. The diagram shows the movable range for the wireless antenna. Do not try to
force it beyond this range otherwise you may break it.
3. AUDIO IN jacks: Input AV component audio signals with an analog audio cable.
4. SIGNAL GND terminal: The ground wire of the turntable is connected.
5. DIGITAL IN OPTICAL/COAXIAL jacks: Input TV or AV component digital audio signals
with a digital optical cable or digital coaxial cable.
6. SETUP MIC jack: The supplied speaker setup microphone is connected.
7. Power cord
8. NETWORK port: Connect to the network with an Ethernet cable.
9. HDMI OUT jack: Connect a HDMI cable to transfer video signals and audio signals to a
TV.
10.HDMI IN jacks: Input video signals and audio signals with a HDMI cable connected to an
AV component.
11. SPEAKERS terminals: Connect speakers with speaker cables. When using banana
plugs, first tighten the speaker terminals and then insert the banana plugs.
12.SUBWOOFER PRE OUT jack: Connect a powered subwoofer with a subwoofer cable.
4
> Install
> Initial Setup
> Playback
Advanced Setup | Firmware Update | Others
90°
180°
E
N
Capítulos
Tabla de contenido
Solución de problemas
