Tabla de contenido
Idiomas disponibles
Idiomas disponibles
6
Control panel
Programme selection buttons
With these buttons you can select the washing programme. Press a programme button,
the related indicator light comes on. Refer to 'Washing programmes' chapter for more data
about the washing programmes.
Delay start button
Use the delay start button to delay the start of the washing programme with an interval
of 3, 6 or 9 hours. Refer to the chapter 'Setting and starting a washing programme'.
Function buttons
Use the function buttons for these operations:
• To set the water softener. Refer to the chapter 'Setting the water softener'.
• To deactivate/activate the audible signals. Refer to the section 'Audible signals'.
• To deactivate/activate the rinse aid dispenser when multitab function is active. Refer to
the chapter 'Multitab function'.
• To cancel the washing programme in progress or a delay start in progress. Refer to the
chapter 'Setting and starting a washing programme'.
Setting mode
The appliance must be in setting mode for these operations:
• To set a washing programme.
• To set the water softener level.
• To deactivate/activate the audible signals.
• To deactivate/activate the rinse aid dispenser.
Press the on/off button. The appliance is in setting mode when:
• All the programme indicator lights come on.
Press the on/off button. The appliance is not in setting mode when:
• Only one programme indicator light comes on.
• A washing programme is set. It is necessary to cancel the programme to go back to the
setting mode. Refer to the chapter 'Setting and starting a washing programme'.
Audible signals
You can hear an audible signal:
• At the end of the washing programme.
• During the setting of the level of the water softener.
• When the appliance has a malfunction.
The activation of the audible signals is set at the factory.
Do these steps to deactivate the audible signals:
1. Switch on the appliance.
2. Make sure that the appliance is in setting mode.
3. Press and hold function buttons B and C until the indicator lights of function buttons
A, B and C start to flash.
4. Press the function button C.
– Indicator lights for function buttons A and B go off.
– Indicator light for function button C starts to flash.
– The end-of-programme indicator light comes on.
Capítulos
Tabla de contenido
