Basic Operation - Teac LP-R660USB Manual Del Usuario

H Skip/Search (.m/,/), TUNING (
In CD mode, use these buttons to skip tracks.
Hold down these buttons to search for a part of a track.
In FM/AM mode, use these buttons to tune in a station.
I RECORD
Use this button to enter record pause mode.
J CD operation buttons
PLAY/PAUSE (y/J)
Use this button to start or pause playback or recording.
STOP (H)
Use this button to stop playback or recording.
K Speakers (stereo)
L OPEN/CLOSE (L)
Use this button to open or close the disc tray.
M
Remote Sensor
When operating the remote control unit, point it toward the
remote sensor.
N
VOLUME
Turn this knob to adjust the volume.
O
Disc Tray
P REC LEVEL
In record pause mode, use this knob to adjust the recording level.
Q PHONES
When you use headphones, first reduce the volume level to
minimum. Then, insert the plug from your headphones into the
PHONES jack, and turn the volume up gradually by turning the
VOLUME knob.
< Do not turn the unit on or off, or insert or pull out the
headphones jack while wearing the headphones.
(Excessive sounds may occur from the headphones.)
< The sound from speakers will be cut off while the headphones
are plugged in.
The following buttons are provided only on
the remote control unit.
R PROGRAM
In CD mode, use this button to program tracks.
S CLEAR
In CD mode, use this button to clear the program you set.
T REPEAT
In CD mode, use this button to select a repeat mode setting.
U DISPLAY
In CD mode, use this button to change the display.
V SHUFFLE
In CD mode, use this button for shuffle playback.
Note:
To simplify explanations, instructions in this document refer
to only the names of buttons and controls on the front panel,
making no mention of the use of remote control unit.
)
1 Press the POWER button to turn the unit on.
2 Select a source by pressing the corresponding button.
< To listen to an external source connected to AUX jacks, select
AUX by pressing the PHONO/TAPE/AUX button once or twice.
3
Play the source, and adjust the volume by turning the
VOLUME knob.

Basic Operation

13