HIKOKI SB 10V2 Instrucciones De Manejo página 6

English
BELT SANDER SAFETY WARNINGS
Hold power tool by insulated gripping surfaces, because
the belt may contact its own cord. Cutting a "live" wire
may make exposed metal parts of the power tool "live"
and could give the operator an electric shock.
CAUTION
Prior to the sanding operation, make sure the
material you are going to sand.
SPECIFICATIONS
Model
Voltage (by areas)*
Power input*
No–load belt speed
Sanding belt size
Weight (without cord)
* Be sure to check the nameplate on product as it is subject to change by areas.
STANDARD ACCESSORIES
(1) Endless sanding belt (Grain size: #80) ................ 1
(2) Dust bag .................................................................... 1
Standard accessories are subject to change without
notice.
OPTIONAL ACCESSORIES
(sold separately)
1. Endless sanding belts
Table1
Grain size
40
60
80
100
120
150
180
240
NOTE:
The endless sanding belt is sold in package of 10
belts of the same type. When ordering, specify the
grain type and grain size desired.
2. Stationary Stand
When sanding small articles, use a stationary stand
for convenience.
Optional accessories are subject to change without notice.
APPLICATIONS
Finish sanding and finish flooring of woodwork
products.
5
SB10V2
(110 V, 120 V, 127 V, 220 V, 230 V, 240 V)
240 – 420 m /min
Grain Type
AA, WA, CC
AA, WA, CC
AA, WA, CC
AA, WA, CC
AA, WA, CC
AA, WA, CC
AA, WA, CC
AA, WA, CC
If generation of harmful/ toxic dusts such as lead
paint, woods and metals is expected under the
sanding operation, make sure the dust bag or
appropriate dust extraction system is connected
with dust outlet tightly.
Wear the dust mask additionally, if available.
Do not inhale or touch the harmful / toxic dusts
generated in sanding operation, the dust can
endanger the health of yourself and bystanders.
1020 W
100 × 610 mm
5.2 kg
Base polishing of wood-coated surfaces.
Finish sanding of metal surfaces.
Base polishing of metal-coated surfaces, rust
removal, or paint removal prior to refinishing.
Surface finishing of slate, concrete, and similar
materials.
PRIOR TO OPERATION
1. Power source
Ensure that the power source to be utilized conforms
to the power requirements specified on the product
nameplate.
2. Power switch
Ensure that the power switch is in the OFF position.
If the plug is connected to a receptacle while the
power switch is in the ON position, the power tool
will start operating immediately, which could cause
a serious accident.
3. Extension cord
When the work area is removed from the power
source, use an extension cord of sufficient thickness
an rated capacity. The extension cord should be
kept as short as practicable.
4. Attach the sanding belt
For details, refer to the section on "Sanding Belt
Assembly".
5. RCD
The use of a residual current device with a rated
residual current of 30mA or less at all times is
recommended.
HOW TO HANDLE SANDING BELT
CAUTION:
Be sure to switch power OFF and disconnect the
plug from the receptacle to avoid serious trouble.
SB10S2
420 m /min