Idiomas disponibles
Idiomas disponibles
English
TROUBLESHOOTING
Use the inspections in the table below if the tool does not operate normally. If this does not remedy the problem, consult your
dealer or the HiKOKI Authorized Service Center.
1. Power tool
Symptom
Tool doesn't run
Tool suddenly stopped
Suddenly stopped
Motor speed declined
during operation
Doesn't cut well
Switch can't be pulled
Sawdust discharge is poor
Battery cannot be installed
Possible cause
No remaining battery power
Battery isn't fully installed.
Motor is overloaded
Overload protection is in operation.
The battery is overheated.
Motor was continuously overloaded.
Motor was continuously overloaded.
The saw blade is worn or missing teeth.
The bolt is loose.
The saw blade is installed backwards.
The switch lock is not pushed in enough.
Sawdust has accumulated in the saw cover. Remove the sawdust inside the saw cover.
Attempting to install a battery other than that
specifi ed for the tool.
Charge the battery.
Push the battery in until you hear a click.
Get rid of the problem causing the
overloaded.
Let the battery cool down.
Refer to "LED LIGHT WARNING SIGNALS".
Refer to "LED LIGHT WARNING SIGNALS".
Replace with a new saw blade.
Firmly tighten the bolt.
Install the saw blade in the proper direction.
Push the switch lock in all the way.
Please install a multi volt type battery.
20
Remedy
