Tabla de contenido
Idiomas disponibles
Idiomas disponibles
4....-05-FMI 2696
muscle and/or joint pain. Prolonged pain may be symptomatic of a serious
disease.
•
A massage should have a pleasant and relaxing effect. If you feel discomfort or
pain after a massage you should consult a doctor before using the device again.
•
Never use massage machines with open wounds, body parts with circulation
disorders, swellings, burns, inflammations or skin sores or pus wounds.
Footbath
•
Place the appliance on the floor so that you can sit comfortably in front of it.
•
Fill the appliance with warm or cold water up to a maximum of two filling marks
located on the appliance's inner wall.
•
Only connect the machine to a properly installed safety socket, 230 V/50 Hz.
•
Sit down and put your feet in the appliance.
•
Select the desired function mode. Turn the button in a clockwise direction in
order to make the following adjustments:
0 – Off/OFF
1 – Massage + Warm + Infrared
2 – Massage + Warm + Whirl + Infrared + water jet
3 – Whirl + Warm + water jet
•
Enjoy the deep-penetrating massage while moving your feet forward and back-
ward over the reflex zone massage rollers. The roller plates can be easily remo-
ved by pulling them out. When using the appliance without the roller plates fit in
the standard plate.
•
After use:
Turn off the appliance after use and pull the plug. Always pour the water out
sideways next to the infrared lamp.
Never pour water over the function selector switch.
Attention: The purpose of the heat generated by the appliance is not exclusively
for the warming of the water. It is generated to avoid its rapid cooling.
With the roller insert below the infrared light you can increase the massage effect.
Infrared function
Place the function selector either on 1 or 2.
Place one foot on the central console. Exert more or less pressure as you please.
•
Before cleaning remove the plug from the socket.
•
The spray water protection device can be pulled up in order to facilitate clea-
ning.
•
Next to the water jet head there is a wire mesh. After the machine has been
used a few times this should be cleaned (with a soft brush if necessary).
04.02.2002 9:33 Uhr
Use
Cleaning
Seite 27
27
GB
Tabla de contenido
