Idiomas disponibles
Idiomas disponibles
EN
Description and location of machine parts
FIG. A & B
Protection switch
01
Frame
02
Table
03
Blade
04
Parallel guide
05
Angle guide
06
Protective casing
07
Dust collector
08
Table inclination
09
Cutting height setting
10
Belt tension
11
Blade tension
12
Upper wheel inclination
13
Cutting height lock
14
-
15
Casing lock
16
Upper blade guiding lock
17
Lower blade guiding lock
18
-
19
Compass point
20
Contents of box
FIG. C
Assembling the machine
FIG. D
Frame assembly
01
Table assembly
02
Blade assembly (see blade setting)
03
Functions of the machine
FIG. E
Start-up and shutdown
01
Cutting height setting
02
Table orientation
03
Guide operation (90°/45°)
04
How to change speed
05
Connection to an extractor
06
-
07
Belt tension
08
Circular cutting
09
113292-2-Manual-H.indd 25
Settings of the machine
FIG. F
CAUTION: Perform the setting while
switched off and by hand.
Make sure that the strip does not touch
any metal or plastic part.
Blade setting
01
- Blade positioning on wheels
- Blade tension setting
- Upper guiding block side block
and backstop setting
- Lower guiding block side block
and backstop setting
Set the cutting to 90°
02
Replacing consumables
FIG. G
Blade replacement
01
Belt replacement
02
-
03
Maintenance, recommendations and advice
Always use a suitable blade for
01
the material that is not damaged
Each time the blade is replaced,
02
check the settings
When idle, slacken the blade tension
03
slightly to relieve the strain on the machine
Do not use for cutting firewood
04
Check that the wood does not contain
05
any metal parts (nails, screws, etc.) liable to
damage the blade.
EN
09/07/2018 15:24
