Skil 4395 Instrucciones De Funcionamiento página 9

SM 1619X07434 02-12:SM 1619X07434 02-12.qxp 2/14/12 9:11 AM Page 9
LASER LIGHT ON/OFF BUTTON
(Model 4495 only)
The laser "ON/OFF" button allows you to turn
the laser feature on or off.
To turn laser ON, depress the button.
To turn laser OFF, depress the button again.
TO ADJUST THE LASER LINE GUIDE
Your laser line guide is pre-set at the factory
and should not need adjustment. If adjustment
is required, use a flat head screwdriver to turn
the adjustment screw located on the side of
the laser module (Fig. 4). Turn on the laser
light ON. Rotate the adjustment screw until the
laser line is in the center of the blade. There is
no need to turn the tool "ON" while adjusting
the light beam.
• AVOID EXPOSURE - • EVITE LA EXPOSICIÓN.
LASER RADIATION DESDE ESTA ABERTURA SE
EMITE RADIACIÓN LÁSER.
IS EMITTED FROM
THIS APERTURE.
• ÉVITER L'EXPOSITION -
RAYONNE MENT LASER
ÉMIS PAR CETTE
OUVERTURE.
BLADE STORAGE COMPARTMENT
Your tool is equipped with a blade storage
compartment on the backside of your saw
(Fig. 5). To open, pull compartment in direction
of arrow. To close, push compartment toward
the tool until it snaps into place.
Be sure compartment is closed to prevent
blades from falling out.
The Laser line guide has a limited amount of
travel. Do not continue to turn the adjustment
screw after the line stops moving or if it
becomes significantly harder to turn the screw.
Overturning the adjustment screw may cause
the adjustment system to break or cause the
adjustment screw to fall out of the tool.
USING THE LASER LINE GUIDE
Only turn on the laser light on when the tool is
on the workpiece.
1. First mark the line of cut on your workpiece
(good side down.)
2. Insert plug into the power source.
3. Place the front edge of the saw foot on the
workpiece, turn laser light ON and align beam
with the line of cut .
FIG. 4
4. Hold the tool firmly, squeeze the trigger and
allow the tool to reach desired speed.
5. Press down (to keep the saw foot flat
LASER LIGHT
against the work surface) as you slowly push
ADJUSTMENT
the saw forward, keeping the beam in line with
SCREW
the line of cut .
6. After completion of the cut, turn the laser
light OFF.
COMPLIES WITH FDA
21CFR1040.10 AND 1040.11
-9-
LASER RADIATION - AVOID
DIRECT EYE EXPOSURE
WAVELENGTH: 650 nm
Max. Output: < 5 mW
CLASS IIIa LASER PRODUCT
RADIACIÓN LÁSER: EVITE LA
EXPOSICIÓN DIRECTA DE LOS OJOS
RAYONNEMENT LASER - ÉVITER
D'Y EXPOSER DIRECTEMENT LES YEUX
FIG. 5
BLADE
STORAGE
COMPARTMENT