Idiomas disponibles
Idiomas disponibles
CLEANING
AND
MAINTENANCE
PRECAUTION
INSTRUCTIONS
WARNING!
-
the
cleaning
and
disconnect the equipment from the mains power
supply:
-
high temperatures can be reached inside the
machine (90°C). ASfter power supply has been
removed, wait until the machine has reached the
room temperature, before working on it.
-
the machine protection degree is IP21, therefore
it should not be washed with direct high pressure
jets of water;
-
never leave tools, parts or other loose material
on or in the machine;
-
BEFORE starting machine or cycle, after any
maintenance or repair work, make sure all
protective are correctly installed;
DAY MAINTENANCE
-
Disconnect the machine with pushbutton "A";
-
Lift
the
overflow pipe and let the water
drain out of the tank;
-
Wash thoroughly the
housing to remove all impurities;
-
Take the filters and clean it under running
water;
POSSIBLE TROUBLES - CAUSES - SOLUTIONS
PROBLEMS
The machine doesn't catch
The water doesn't go in
Insufficient Washing
Insufficient Rinsing
bar - 100 kPa;
FOR ANY OTHER TROUBLE, CALL SERVICE
PREVENTIVE
AND
CLEANING
: Before carrying-out
maintenance
operations,
tank and
the filters
CAUSES
Main switch is switched off;
Water cock closed;
The Overflow is not in its place;
place;
Wrong detergent or dosage
insufficient;
Low temperature in the tank;
Dirt wash filter;
Rinsing nozzles blocked;
Hydraulic pressure lower than
a booster pump;
-
Re-assemble the overflow
filters in their housings;
-
Check and clean the washing and the rinsing
jets
! Daily disassemble the lower and upper wash
arms by working on the „big" ring nut, like
in the picture.
-
Clean the outer surface of the machine by
using a wet sponge; don't use water jets
because, beside being dangerous they could
damage the electrical parts; don't use abrasive
detergents;
-
When the machine is to remain idle
long time, drain all the water
boiler (the
lower side of the boiler)
electropump. Also leave the
open.
ATTENTION!
out cleaning the inside of the machine, make sure that
there are no foreign objects that could damage the
rusty steel inside the tank. The eventual rust particles
could come from non-stainless steel dishes, from
baskets or damaged water pipes not rust-proof.
NEVER WASH THE EXTERNAL PART
MACHINE WITH A WATER JET
SOLUTIONS
Turn ON the main switch;
Open water cock;
Reassemble the Overflow in its
Use anti-foam detergent in the
right dosage and never with
cold water;
Wait untill the water gets hot;
Clean filter;
Unscrew and clean nozzles
under running water;
Wait till the pressure is on or buy 1
20
pipe
from
drain plug
is located on the
and
from
wash
. Before carrying
and the
for a
the
the
tank
OF THE
