Jacuzzi ALLUSION 6636 Manual De Instalación Y Operación página 3

PRECAUTIONS
• • • • •
Do not operate the whirlpool system unless the bath is filled with water to at least 1" above the highest jet.
• • • • •
Do not immerse the control panel by overfilling the bath.
• • • • •
Do not use oil-based bath additives in your whirlpool bath.
• • • • •
When cleaning your bath, do not use abrasive substances which will damage the bath's surface.
• • • • •
To prevent discoloration of the acrylic finish, do not fill the bath with water in excess of 140°F (60°C).
• • • • •
The whirlpool system should be purged at least twice a month. For your convenience, we have developed a plumbing
system cleaner (Systems Clean™) specifically for whirlpool baths. For availability call 1-800-288-4002.
• • • • •
Use this unit only for its intended purpose as described in this manual. Do not use attachments not recommended by the
manufacturer.
• • • • •
This unit must be connected only to a supply circuit that is protected by a Ground Fault Circuit Interrupter (GFCI). Such
a GFCI should be provided by the installer and should be tested on a routine basis. To test the GFCI, push the test button.
The GFCI should interrupt power. Push the reset button. Power should be restored. If the GFCI fails to operate in this
manner, there is a ground current flowing, indicating a possibility of an electric shock. Do not use this unit. Disconnect
the unit and have the problem corrected by a qualified electrician before using.
• • • • •
A pressure wire connector is provided on the exterior of the motor to permit connection of an No. 8 AWG (8.4 mm) solid
copper bonding conductor between this unit and all other electric equipment and exposed metal in the vicinity, as needed
to comply with local requirements.
• • • • •
This unit should be electrically grounded and installed by a licensed contractor, electrician, and plumber.
• • • • •
For built-in and drop-in units, install to permit access for servicing.
Note: This is a professional grade product. A knowledge of construction techniques, plumbing and electri-
cal installation according to codes are required for proper installation and user satisfaction. We recommend
that a licensed contractor perform the installation of all Jacuzzi Whirlpool Bath products. Our warranty does
not cover improper installation related problems.
PRODUCT SPECIFICATIONS ARE SUBJECT TO CHANGE WITHOUT NOTICE.
USE INSTALLATION INSTRUCTIONS SUPPLIED WITH PRODUCT.
The Company has obtained applicable code (standards) listings generally available on a national basis for products of this type.
It is the responsibility of the installer/owner to determine specific local code compliance prior to installation of the product. The
Company makes no representation or warranty regarding, and will not be responsible for any code compliance.