HWAM 3110 Instrucciones De Montaje página 14

a I
SSEMBLy NSTRucTIONS FOR cOMBuSTION aIR SySTEM
Rear connection (drawing A + B)
1. Remove the top plate (1).
2. Loosen and remove the bolt (2) that holds the two sides together. Loosen the bolt (3) that holds
the left side in position slightly, but do not remove it. Lift the left side (4) about 10 mm and pull it
away from the stove so that it is lifted free of the guide pins in the bottom plate of the stove. Repeat
with the right side (5).
3. Loosen and remove the 4 Allen bolts (6) behind the heat shield (7). Lift the heat shield slightly and
pull it away from the stove.
4. Attach the accompanying gasket (8) to the edge of the heat screen (9+10).
5. Insert the connector bush (15) into the hole in the heat shield from the inside. Secure the connector
bush with 3 self-tapping screws (16). Fasten the screws as shown on the drawing.
6. Attach the flexible hose (17) to the connector bush and pull the insulation sleeve (18) onto the
flexi- hose.
7. Remove the plate (25) in the bottom of each of the stove sides by tapping on in with a soft hammer.
This makes room for the flexi-hose.
8. Place the bottom of the heat shield between the stove and the guide pins (19) at the back of the
bottom plate on the stove and press it in towards the stove. Secure the heat shield with the 4 Allen
bolts (6).
9. Place the right side (5) on the guide pins on the bottom plate of the stove and press it in towards the
stove. Lift the side and press it lightly inwards until it engages behind the bolt (3) at the top. Secure
the bolt (3). Repeat with the left side. Finally secure the bolt (2) that holds the two sides together.
10. Replace the top plate (1) on top of the stove.
11. Use the accompanying rubber plugs (22) to close the holes (23) in the bottom plate of the wood-
burning stove and seal off the fresh air system. HWAM 3110 with a low plinth does not require the
use of rubber plugs (22) since the plinth seals off the holes.
12. Use the accompanying screws (24) to close the holes (21) in the bottom plate of the wood-burning
stove and seal off the fresh air system. HWAM 3110 with a low plinth does not require the use of
screws (24) since the plinth seals off the holes.
13. Adhere the accompanying gasket (26) along the edge of the bottom plate to keep the wood-
burning stove stable.
Bottom connection (drawing A + C + D)
1. Remove the top plate (1).
2. Loosen and remove the bolt (2) that holds the two sides together. Loosen the bolt (3) that holds
the left side in position slightly, but do not remove it. Lift the left side (4) about 10 mm and pull it
away from the stove so that it is lifted free of the guide pins in the bottom plate of the stove. Repeat
with the right side (5).
3. Loosen and remove the 4 Allen bolts (6) behind the heat shield (7). Lift the heat screen slightly and
pull it away from the stove.
14
E
NGLISh