Additional Settings (Option) - Sony CPD-E200 Manual De Instrucciones

Additional settings (OPTION)

You can manually degauss (demagnetize) the monitor, adjust the
moire cancellation level, change the menu position, and lock the
controls.
1
Press the center of the control button.
The main MENU appears on the screen.
2
Move the control button to highlight
press the center of the control button again.
The OPTION menu appears on the screen.
Move the control button m/M to select the desired
3
adjustment item.
Adjust the selected item according to the following
instructions.
Degaussing the screen
The monitor is automatically demagnetized (degaussed) when the
power is turned on.
To manually degauss the monitor, first move the
control button m/M to select
the control button ,.
The screen is degaussed for about 5 seconds. If a second degauss
cycle is needed, allow a minimum interval of 20 minutes for the
best result.
Adjusting the moire*
If elliptical or wavy patterns appear on the screen, adjust the
moire cancellation level.
To adjust the amount of moire cancellation, first move
the control button m/M to select
Then move the control button </, until the moire
effect is at a minimum.
* Moire is a type of natural interference which produces soft, wavy lines
on your screen. It may appear due to interference between the pattern
of the picture on the screen and the phosphor pitch pattern of the
monitor.
Example of moire
OPTION and
(DEGAUSS). Then move
(MOIRE ADJUST).
Changing the menu's position
Change the menu's position if it is blocking an image on the
screen.
To change the menu's on-screen position, first move
the control button m/M to select
for horizontal adjustment, or
vertical adjustment. Then move the control button
</, to shift the on-screen menu.
Locking the controls
To protect adjustment data by locking the controls, first
move the control button m/M to select
LOCK). Then move the control button ,, to select ON.
Only the 1 (power) switch, EXIT, and
of the OPTION menu will operate. If any other items are
selected, the mark appears on the screen.
To cancel the control lock
Repeat the procedure above and set
(OSD H POSITION)
(OSD V POSITION) for
(CONTROL
(CONTROL LOCK)
(CONTROL LOCK) to OFF.
11
US