Tabla de contenido
Idiomas disponibles
Idiomas disponibles
English
LOADING NAILS
● When loading nails into Nailer,
1) do not pull trigger;
2) do not depress push lever; and
3) keep Nailer pointed downward.
(1) Pull the nail feeder back and hang it over the roll pin.
Nail Feeder
Roll pin
(2) 1 Insert nail strips one by one from above the
magazine.
2 Slide nails forward in the magazine.
2
Nail strips
(3) 1 Pull the nail feeder up in backward direction and
remove it from the roll pin.
2 Slide the nail feeder forward until it contacts nails.
Nail Feeder
Roll pin
14
WARNING
1
Magazine
NOTE:
● Use nails at least 5 nails remaining.
● Slide the nail feeder SLOWLY forward.
If the nail feeder is released roughly, it may be stuck
between the magazine and nails, which makes mis-
feeding trouble.
NAILER OPERATION
Read section titled "SAFETY"(pages 3 – 7).
● Operators and others in work
area
glasses with side shields
which conforms to ANSI Z87.1
specifi cations.
Ordinary eyeglasses do not
provide adequate protection.
● Only person who have read
and understand this MANUAL
should operate the Nailer.
● NEVER point tool at yourself
or others in work area.
● Keep fi ngers AWAY from
trigger when not driving nails
to avoid accidental discharge.
● Know and understand what trigger system you
are using.
Please read and understand "Methods of
Operation" below.
● Inspect the Nailer before operating to determine
actuation system.
Before starting work, check the nailing operation
switching device.
This Hitachi nailer includes a nailing operation
switching device.
Before starting work, make sure that the
switching device is properly set.
DANGER
MUST
wear
WARNING
safety
Tabla de contenido
