Mopar 4280361 Manual Del Usuario página 8

8
21. Install the TIPM (1) onto it's bracket. Make sure the
TIPM's upper retaining tabs (2) fully engage.
22. Install the cover back on to TIPM (1).
23. Obtain the kit supplied hood ajar switch plunger (1)
and rivet. Locate the mounting holes on the front pas­
senger side of the hood and position the plunger (1)
to the hood as shown.
24. Lower the hood slightly and check for proper align­
ment between the plunger (1) and hood ajar switch.
25. Once properly aligned, install the rivet to secure the
hood ajar switch plunger.
RESTORE VEHICLE CONFIGURATION
NOTE: The technician should have cut the KEY FOBIK Blanks using the original vehicle's Key FOBIK as a tem­
plate. Please make sure the KEY FOBIK Blanks have been cut prior to programming. If this step has not been
performed, please perform at this time.
CAUTION: Read all notes and cautions for programming procedures.
NOTE: Prior to programming, have the vehicle PIN readily available before running the routine. If necessary,
obtain the four digit PIN from the dealership's parts department.
CAUTION: If the PCM and WCM are replaced at the same time, the PCM MUST be programmed before the WCM.
1. When prompted, enter the four digit pin number obtained from the dealership parts department.
2. Connect a battery charger to the vehicle.
3. With the wiTECH diagnostic application, perform the following steps form the Initial Start Up Screen:
• Select the "DIAGNOSTIC PROCEDURES" tab
• Highlight "RESTORE VEHICLE CONFIGURATION"
• Select the "Run Diagnostic" button
• Select "CONTINUE"
• Verify that the vehicle VIN number is correct
• Once verified, select the "Correct VIN" button
Jan 19, 2011
4280361
K6861248