Tabla de contenido
Idiomas disponibles
Idiomas disponibles
1
007534
CAUTION:
Do not use a deformed or cracked blade. Replace
•
it with a new one.
Do not stack materials when cutting them.
•
Do not cut hardened steel, stainless steel, wood,
•
plastics, concrete, tile, etc. Cut only mild steel
and aluminum.
Do not touch the blade, workpiece or cutting chips
•
with your bare hand immediately after cutting, they
may be extremely hot and could burn your skin.
Always use the blades appropriate for your job. The
•
use of inappropriate blades may cause a poor cutting
performance and/or present a risk of personal injury.
Rip fence (guide rule) (Accessory)
2
007532
The handy rip fence allows you to do extra-accurate
straight cuts. Simply slide the rip fence up snugly against
the side of the workpiece and secure it in position with
the screw on the front of the base. It also makes
repeated cuts of uniform width possible.
MAINTENANCE
CAUTION:
Always be sure that the tool is switched off and the
•
battery cartridge is removed before attempting to
perform inspection or maintenance.
Clean out the upper and lower guards to ensure
•
there is no accumulated sawdust which may
impede the operation of the lower guarding
system. A dirty guarding system may limit the proper
operation which could result in serious personal injury.
The most effective way to accomplish this cleaning is
with compressed air. If the dust is being blown out
of the guards be sure the proper eye and
breathing protection is used.
1. Cutting line
2. Base
3. Sight grooves
2
3
1. Clamping screw
2. Rip fence
(Guide rule)
1
Never use gasoline, benzine, thinner, alcohol or
•
the like. Discoloration, deformation or cracks may
result.
Inspecting blade
Check the blade carefully for cracks or damage
•
before and after each use. Replace a cracked or
damaged blade immediately.
Continuing to use a dull blade may cause a
•
dangerous
kickback
Replace with a new blade as soon as it no longer
cuts effectively.
Blades
for
•
re-sharpened.
Replacing carbon brushes
001145
Remove and check the carbon brushes regularly.
Replace when they wear down to the limit mark. Keep
the carbon brushes clean and free to slip in the holders.
Both carbon brushes should be replaced at the same
time. Use only identical carbon brushes.
007533
Use a screwdriver to remove the brush holder caps.
Take out the worn carbon brushes, insert the new ones
and secure the brush holder caps.
After replacing brushes, insert the battery cartridge into
the tool and break in brushes by running tool with no
load for about 1 minute. Then check the tool while
running and electric brake operation when releasing the
switch trigger. If electric brake is not working well, ask
your local Makita service center for repair.
To maintain product SAFETY and RELIABILITY, repairs,
any other maintenance or adjustment should be
performed by Makita Authorized or Factory Service
Centers, always using Makita replacement parts.
9
and/or
motor
metal
cutter
cannot
1. Limit mark
1
1. Brush holder
1
cap
2. Screwdriver
2
overload.
be
Tabla de contenido
