Husqvarna 555 Manual Del Usuario página 25

To do a check of the vibration damping
system
1. Make sure that there are no cracks or deformation
on the vibration damping units.
2. Make sure that the vibration damping units are
correctly attached to the engine unit and handle unit.
Product overview on page 2 for information
Refer to
about where the vibration damping system is on your
product.
To do a check of the start/stop switch
1. Start the engine.
2. Press the start/stop switch down to the STOP
position. The engine must stop.
Your product has the function that adjusts the carburetor
automatically, which gives the best possible adjustment.
lets the engine adapt to weather conditions, altitude,
gasoline and the type of two-stroke oil.
CAUTION: If does not work correctly, speak
to your servicing dealer. The product adjusts
correctly after some fuelings.
To do a check of the muffler
WARNING: Do not use a product that has a
defective muffler or a muffler that is in bad
condition.
WARNING: Do not use a product if the spark
arrestor mesh on the muffler is missing or
defective.
1. Examine the muffler for damages and defects.
587 - 004 - 15.04.2020
2. Make sure that the muffler is correctly attached to
the product.
3. If your product has a special spark arrestor mesh,
clean the spark arrestor mesh weekly.
4. Replace a damaged spark arrestor mesh.
CAUTION: If the spark arrestor mesh is
blocked, the product becomes too hot and
this causes damage to the cylinder and
piston.
To replace a broken or worn starter
rope
1. Loosen the screws to the starter housing.
2. Remove the starter housing.
3. Pull out the starter rope approximately 30 cm/12 in
and put it in the notch on the pulley.
25