Cleaning And Storage - Beurer LW 110 Instrucciones De Uso

Graphic displayed
The air washer is switched off by pressing the On/off button
Regularly check the water level gauge during operation and refill the tub if necessary.
Note:
• The actual humidification output depends on the ambient conditions and the air contact with the
humidification discs. In principle, the lower the relative air humidity, the higher the humidification,
and the greater the damp contact surface with the air, the higher the humidification.
• The LCD illumination reduces 5 seconds after a button has been pressed. The reduced display
illumination enables the device to be operated in bedrooms.
• Use fan level 1 to operate the device during the night.

7. Cleaning and storage

Regular cleaning is a prerequisite for hygienic and fault-free operation.
The air washer can be dismantled easily and without tools for cleaning.
Always empty and thoroughly clean the air washer if the device contains water and has not been operated
for longer than 3 days.
A lack of cleaning and hygiene can cause bacteria and fungi to form in the water.
Rinsing the tub
Rinse out the tub every 2 weeks with clean water. If the air is heavily polluted, the device is used intensively
or the water quality is poor, the air washer must be cleaned at shorter intervals. If necessary, remove any
deposits in the tub using a plastic brush.
Cleaning the fan unit
You can wipe the fan unit with a damp cloth. However, make sure that no liquid enters the fan unit.
Cleaning the upper cover
Remove the fan unit to more easily clean the upper cover. To do so,
slide the 4 locks to the outside and remove the fan unit.
Important: When putting the fan unit down, ensure that it does not
come to rest on the water level sensor.
Cleaning the humidification discs and tub
You can wipe the humidification discs and tub with a damp
cloth or clean them thoroughly and easily in the dishwasher.
Lift off the upper cover, remove the humidification discs
from the tub and place them in the dishwasher. Unlock
the water level sensor (Figure 1) and remove it (Figure 2). If
there is insufficient space in the dishwasher, create extra
space by removing the cutlery basket, for example. The
humidification discs and tub must not be bent or jammed
when being placed in the dishwasher.
Set the dishwasher to a gentle cycle (for cleaning glass) and if possible remove the part before the drying
process. The cycle must not exceed a temperature of 50 °C – otherwise the plastic parts may deform.
Only continue to use the device when the exterior of the tub is completely dry.
Fill level
Residual water in tub.
The tank must be refilled.
Device automatically switches off after 6 hours.
The device has switched itself off due to safety reasons. Clean and refill the
device before next use.
on the upper side.
Figure 1
15
Figure 2