Fixing Your Xelos A 42 Tv To The Xelos A 42 Rack - Loewe Xelos Rack Instrucciones De Montaje

Fixing your Xelos A 42 TV to the Xelos A 42 Rack Art. No. 64496 A01
Procedure
There is a threaded hole in the adapter. Fix the cable tie there for
later fastening of the connecting leads.
Place the adapter on the holder in the rack so that the cable tie is
at the back of the rack. The holders in the adapter for the TV set are
also tilted back slightly.
Fix the adapter (fi g. 3) to the Xelos Rack with the 4 screws. Tighten
the screws with the wrench provided.
The TV set should be held vertically over the adapter on the Xelos A
42 Rack by two persons.
Please make sure that the holders on the TV set and the adapter
(holders tilted back slightly) are exactly one above the other.
Drop the two rails of the TV set into the holders of the adapter.
Four clamping screws and the corresponding wrench were
delivered with the Xelos A 42 Rack.
Screw in the clamping screws (fi g. 3, position on the adapter
marked by reference line and arrow).
After the TV set is installed, tighten the clamping screws.
Covers on the Xelos A 42 Rack
Lift the rear cover (fi g. 3, arrow 1) until it is released and pull the
cover (fi g. 3, arrow 1) off to the rear.
Then pull the cover (fi g. 3, arrow 2) up and out in the guide groove.
Note
When moving its location your screen with the Xelos A 42 Rack should not be lifted and carried by the
screen. The connection between the screen and the rack may slip apart.
Transport the devices separately.
Further information such as connecting your screen or service addresses can be found in your TV Instruc-
tion Manual.
8
fi g. 3
ANT-SAT
89352.001
13/18 V 350 mA /
ANT-TV
5 V 80 mA /
1
AUD IO IN AUD IO OU T
C L R L R SERVIC E
SD/ HD- COMP ONE NT IN AUD IO DIGITA L HDTV IN
AV 1 AV 2
( )
( RGB / YUV ) C /P b b C /P r r Y IN OUT HDM I D VI VGA/ XGA
clamping screw
adapter
cable tie
2