Loewe Xelos Rack Instrucciones De Montaje página 6

Fixing Xelos SL 32, SL 37 and Xelos A 32 and A 37 TV sets to the Xelos Rack
Removing the connection cover
There is a lug (fi g. 1, arrow A1 and A2) on the right and left hand sides of
the cover (fi g. 1, arrow A). Push the two lugs in the direction of the arrow
(fi g. 1, arrow A1 and A2), tip the cover outwards and remove it.
Further procedure
Have the two cylinder-head screws with mounted toothed washers and the
wrench provided at the ready.
Place the Xelos rack at its later destination.
Please note that the screen weighs about 20 – 40 kg
depending on the type of set!
Two persons should hold the screen above the Xelos Rack.
Make sure that the standard holder grips over its counterpart on the Xelos
Rack when the screen is lowered.
Attention!
Hold the screen tight until it is screwed to the Xelos
Rack.
The screen is correctly positioned when the holes in the standard
holder (screen) and the holder (Xelos Rack) are in line.
Insert the cylinder-head screws with fi tted toothed washers in the
holes in the standard holder and the holder on the Xelos Rack.
Screw the cylinder-head screws into the threads in the standard
holder.
Tighten the cylinder-head screws with the wrench.
Covers on the Xelos Rack
Lift the rear cover (fi g. 1, arrow B) until it is released and pull the cover (fi g. 1, arrow B) off to the rear.
Then pull the cover (fi g. 1, arrow C) up and out in the guide groove.
6
fi g. 1
A1 A2
A
B B
C