Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Safety • Installation
10. When wiring an electrically driven pump,
follow all electrical and safety codes, as
well as most recent National Electrical Code
(NEC) and Occupational Safety and Health
Act (OSHA).
11.
Risk of electric shock . Can
shock, burn or kill. This equipment is only for
use on 115 volt (single phase) and is equipped
with an approved 3-conductor cord and
3-prong, grounding-type plug.
•
To reduce risk of electric shock, be certain
that it is connected to properly grounded,
grounding-type receptacle.
•
Never connect green (or green and yellow)
wire in cord to a live terminal!
•
Where a 2-prong wall receptacle is
encountered, it must be replaced with properly
grounded 3-prong receptacle installed in
accordance with the National Electrical Code
and local codes and ordinances.
12. All wiring should be performed by a
qualified electrician.
13. Make certain that power source conforms to
requirements of your equipment.
14. Protect electrical cord from sharp objects, hot
surfaces, oil, and chemicals. Avoid kinking
cord. Replace or repair damaged or worn
cords immediately.
15. Do not touch an operating motor. Motors can
operate at high temperatures.
16. Do not handle pump or pump motor with
wet hands or when standing on wet or damp
surface, or in water.
Risk of electric shock . Can
shock, burn or kill. If your basement has
water or moisture on floor, do not walk on
wet area until all power has been turned off.
If shut-off box is in basement, call electric
company to shut-off service to house, or call
local fire department for instructions. Remove
pump and repair or replace. Failure to follow
this warning can result in fatal electrical shock.
Risk of fire and explosion .
Can cause severe injury, property damage
or death. Do not use in hazardous or
explosive locations.
Installation
About 8"
1. This unit can be installed in sump pit with
minimum diameter of 12" (30cm) and depth
of 12" (30cm). Sump pit may be constructed
of tile, concrete, steel or plastic. Check local
codes for approved materials.
2. Install pump on solid, level foundation, as near
as possible to center of sump pit. Do not hang
pump from discharge pipe or power cord.
Risk of burns . Pump must
be level (column must be vertical) when
operating. If motor is tilted, internal start/run
switch may overheat and damage motor.
3. Pump should not be installed on clay, earth or
sand surfaces. Clean sump pit of small stones
and gravel which could clog the pump. Keep
pump inlet screen clear.
4. Thread discharge pipe into pump body
carefully to avoid stripping or crossing threads.
NOTICE Do not use ordinary pipe joint
compound on plastic pipe or pump. Pipe
joint compound can attack plastics and
damage pump.
Discharge
About 6"
Check
Valve
(Purchase
Separately)
5098 0705
4
Tabla de contenido
