Bourgeat Sherpa FC3 Instrucciones De Uso página 10

After treatment, wash thoroughly with water and wipe.
The use of acid is reserved to skilled persons and complying with regulations.
Product to ban :
- Javel water and chlorine based products
- hydrochloric acid
- iron oxide abrasive powders.
y Sherpa front opening container: "E1" display on the regulator: probe problem.
y Resetting the safety thermostat :
- Sherpa Container with a front opening: by removing the heater unit, then the grey cover which is fixed by 4 screws.
y For any other maintenance work, please contact an approved after-sales agent.
This equipment carries the recycling symbol in accordance with Directives 2002/95/CE and 2002/96/CE relating to Waste
Electrical or Electronic Equipment (DEEE or WEEE) At the end of its working life the equipment should be recycled in
accordance with the regulations that are in force in the country of its installation.
FRONT OPENING BOX
Wheels fitting on the front opening container «Sherpa» and euronorme container
y Attach the wheels with brakes at the front of the container, and the wheels without brakes at the back with the screws
provided.
y Euronorme Container: 4 screws per wheel.
y «Sherpa» insulated box :
- Remove the 4 black wearing shoes.
Place large washer A between the wheel and the container, and small washer B on screw C.
-
- Place a few drops of resin from bottle D on screw C thread.
- Tighten the screw with a 13 mm socket key or 6 mm Allen key according to the models.
- Wait 24 hours before using the brakes on the container.
LIQUID CONTAINERS
y These containers are delivered with an stainless steel gastronorm tank that permits loading with liquids at 100°C.
y It prevents odours and taste being transferred from one load to another.
y We recommend that the tap on liquid containers be washed regularly, particularly after transporting milk. The tap can be
removed and replaced by hand.
y Put the gastro container A correctly inside the insulated box.
y Put the joint C on the tube B.
y Place assembly in the tap aperture from the interior.
y Tighten the nut D with hand.
y Put the nut E (thread towards the outside).
y Put the circlip F (crescent-shaped steel-colored component)
y Screw on the nut E at the top of the tap.
y Dismantling : act in the reverse order.
10
Maintenance
Hot transportation - Cold transportation
Assembly Dismantling of the tap