Emission Of Harmful Substances; End Of Cycle; Maintenance - Tecno-gaz Ekstraplus PT001TTM Instrucciones De Uso

10
Toxic mists are produced by the liquids used to perform maintenance on the instruments. The door
seal is fundamental for safety in the working environment and hence, for the operator. Periodically
make sure that the door seal is perfectly efficient.
The liquids used, together with the relative mists, if any, are extracted through the chamber drain:
- at the end of the cycle
- if the cycle is interrupted (STOP button)
- if an error occurs that interrupts the cycle
TECNO-GAZ CANNOT BE HELD LIABLE FOR ANY DAMAGE DERIVING FROM IMPROPER USE
OF THE MACHINE.
11
The set end of cycle is indicated by a beep and FINISHED CYCLE appearing on the screen.
- Press OK to proceed according to the instructions on the screen
- Press the door to open it
Disconnect the instruments from the stations where maintenance has been performed
- DRY THE INSTRUMENTS WITH A DRY CLOTH
- DRY THE CHAMBER WITH A DRY CLOTH
The maintenance cycle is complete.
12
MAINTENANCE AND
1) ROUTINE MAINTENANCE
The machine does not require any special maintenance.
The components that are most exposed to wear and dirt are:
a) the seal of the door (Fig. 19 Code 1TTMA0072);
b) The seals of the handpiece couplings (Fig. 20 Code 3MECM0006);
The recommended disinfectant can be used for the periodic cleaning of the maintenance chamber and
the cabinet in general.
2) SPECIAL MAINTENANCE
EXTRAORDINARY MAINTENANCE AND REPAIRS MUST BE PERFORMED BY AUTHORISED
PERSONNEL.
3) SPARE PARTS
All accessories that are supplied and provided on request are provided as spare parts.
The mechanical, electrical and electronic components, such as spare parts, are only available for
repairs carried out by authorised personnel.
As previously mentioned any unauthorised intervention is considered as tampering and subject to the
relative consequences (refer to the warranty).

EMISSION OF HARMFUL SUBSTANCES

END OF CYCLE

MAINTENANCE

ENGLISH
27