Skil PWRCORE 20 IW5739-00 Manual Del Propietário página 12

Direction-of-Rotation (Forward/Center-Lock/Reverse) Selector
WARNING
possible injury .
Your tool is equipped with a direction-of-rotation selector, located above the trigger switch.
This selector is used to change the direction of rotation of the bit and to lock the variable-
speed trigger in the "OFF" (center-lock) position (Fig. 3).
a. Position the direction-of-rotation selector to the far right of the tool for forward rotation.
b. Position the direction-of-rotation selector to the far left of the tool for reverse rotation.
c. Setting the switch in "OFF" (center-lock) position helps to reduce the possibility of accidental
starting when not in use.
NOTICE: To prevent gear damage, always allow the impact wrench to come to a complete
stop before changing the direction of rotation.
NOTICE: The impact wrench will not run unless the direction-of-rotation selector is engaged
fully to the left or right.
Fig. 3
Forward
Variable-Speed Trigger Switch
Your tool is equipped with a variable-speed
trigger switch. The tool can be turned "ON" or
"OFF" by depressing or releasing the variable-
speed trigger switch.
The variable-speed trigger switch delivers
higher speed with increased trigger pressure
and lower speed with decreased trigger
pressure (Fig. 4).
12
After tool use, lock the direction-of-rotation selector in the
"OFF"position (center-lock) to help prevent accidental starts and
Center-Lock
Fig. 4
Variable Speed
Trigger Switch
Reverse