Controls And Settings; Direct Controls - Urmet 1092 Manual De Usuario

2

CONTROLS AND SETTINGS

7 6 5
2.1

DIRECT CONTROLS

POWER CONNECTOR (DC) [8]
Plug the power wire of the adapter provided into the respective DC.
ON/OFF BUTTON [1]
This is used to switch the monitor on and off. The green LED (2) lights up when the monitor is on.
IMPORTANT NOTE
If the following message appears on the monitor after pressing the button (1):

it means that "PC" signal input has been selected. To select "AV" signal, press button (6) "SELECT" and select
"AV1 or AV2" by means of buttons (4-5) "◄►". Press "SELECT" again to confirm. The "AV1 o AV2" will appear in
the top right.
If the following message appears on the monitor after pressing the button (1):

it means that 'SV' signal input is selected. The monitor will switch off and the amber LED (2) will light up in this
case. To select "AV" signal, press button (6) "SELECT" and select "AV1 or AV2" by means of buttons (4-5) "◄►".
Press "SELECT" again to confirm. The "AV1 o AV2" will appear in the top left.
If the following message appears on the monitor after pressing the button (1):

despite "AV2 o AV2" input is selected, the monitor was switched off and the amber LED (2) lighted up, it means
that the monitor has detected no video signal on input (13) "AV1 INPUT" or (15) "AV2 INPUT".
DS1092-062B
4 3 2 1
9
8 10
NO CABLE
NO SIGNAL
NO SIGNAL
14
15
11 14
13
12
16