Tabla de contenido
Idiomas disponibles
Idiomas disponibles
ChangBng Engine Oil
Change engine oilafterthefirst5 hoursandevery
50hoursthereafter. If youareusingyourpressure
washer u nderextremely d irtyor dustyconditions, or in
extremely h otweather, c hange oil moreoften.
CAUTION
• Used motor oil has been shown to cause skin cancer in
certain laboratory animals,
• Thoroughly wash exposed areas with soap and water,
KEEP OUT OF REACH
OF CHILDREN.
DON'T
POLLUTE.
CONSERVE
RESOURCES.
RETURN
USED OiL TO
COLLECTION
CENTERS.
Service
Air Cleaner
Your engine will not run properly and may be
damaged if you run it with a dirty air cleaner.
Service the air cleaner once every 25 hours of
operation or once each year, whichever comes first.
Service more often if operating under dirty or dusty
conditions. Replacements are available at your local
Sears service center.
To serv{ce the air cleaner, follow these steps:
1.
Loosen screw and tilt cover down.
Tabs and Slots
Cartridge
Change oil while engBne is still warm from running, as
follows:
1.
Drain fuel tank by running pressure washer until
fuel tank is empty.
2.
Disconnect spark plug wire and keep it away from
spark plug.
3.
Clean area around oil fill, remove oil fill
cap/dipstick. Wipe dipstick clean.
4.
Tip your pressure washer to drain oil from oil fill
into a suitable container making sure you tip your
unit away from spark plug. When crankcase is
empty, return pressure washer to upright position.
5.
Slowly pour recommended
oil (about 20 oz.) into
oil fill opening. Pause to permit oil to settle. Fill to
"Full" mark on dipstick.
6.
Wipe dipstick clean each time oil level is checked.
DO NOT overfill.
7.
Replace and tighten dipstick.
8.
Wipe up any remaining oil.
9.
Reconnect spark plug wire to spark plug.
Base
Screw Cover
2.
Carefully remove cartridge assembly.
3.
To clean cartridge, gently tap pleated paper side
on a flat surface.
4.
Reinstall clean or new cartridge assembly inside
cover.
5.
Insert cover's tabs into slots in bottom of base.
6.
Tilt cover up and tighten screw securely to base.
NOTE: You can purchase new air filter elements by
calling 1-800-366-PART.
Service
Spark
Pmug
Service the spark plug every 100 hours of operation or
yearly, whichever occurs first.
1.
Clean area around spark plug.
2.
Remove and inspect spark plug.
3.
Replace spark plug with recommended
plug if
electrodes are worn or if insulator is cracked or
chipped.
4.
Check electrode gap with wire feeler gauge and
set gap at 0.030 inches (0.76mm), if necessary.
f-_
-._
_
..........
J
]
'\
5.
Install spark plug, tighten securely.
NOTE: You can purchase a new spark plug by calling
1-800-366-PART.
18
Tabla de contenido
