Dyna-Glo DGH474CRP Manual Del Usario página 19

Tabla de contenido
Idiomas disponibles

Idiomas disponibles

Operation instructions
nOte: Other cylinders may be acceptable for use with this appliance provided they are compatible with
the appliance nesting hole and retention means. Refer to Step 16 of the Assembly Instructions for correct
cylinder to cylinder holder connection.
aLL instruCtiOns anD saFeGuarDs On this PaGe Must Be FOLLOweD tO
PreVent Fire, DaMaGe anD/Or inJurY.
COnneCtinG the LP tanK
1. The knob on the LP tank must be closed. Make sure that the knob is turned
full stop. The cylinder supply system must be arranged for vapor withdrawal.
2. Check that the control knob on the control unit is turned off.
3. Remove the protective cap from the LP tank valve and coupling nut.
4. Hold the regulator in one hand and insert the nipple into the valve outlet.
Be sure the nipple is centered in the valve outlet. The coupling nut
connects to the large outside threads on the valve outlet.
Use care – do not cross thread the connection.
5. Hand-tighten the coupling nut
Firmly tighten by hand only. Do not use tools.
to Disconnect: Fully close the tank valve by turning
Turn the coupling nut
detaches.
In the connection process, make sure:
• the regulator inlet connector mates with the cylinder valve outlet properly, safely and firmly, and;
• the LP gas hose does not come in contact or remain in contact with the firebox.
WARNING
clockwise until it comes to a full stop.
counterclockwise until the regulator assembly
WARNING
clockwise.
19
clockwise to a
Tabla de contenido

Solución de problemas

loading

Este manual también es adecuado para:

Dgh474crp-d

Tabla de contenido