Prog-Speed Mode; Auto-Speed/Auto-Sound Mode; Memory-Function - EuroLite LCD-8 Manual Del Usuario

This function is designed for discotheques.

6.4 Prog-Speed Mode

Spots run speed-controlled through internal programs:
In this mode, all 48 programs of the LCD-8 can be run speed-controlled.
You can manually adjust the individual channels via the channel faders, the dimmer fader and via the flash-
buttons.
1. Turn controller ON
2. Press Mode Select until Prog Speed LED is illuminated
3. Adjust dimmer fader for total output
4. Adjust Speed fader until the spots react in the desired speed
5. Select the desired program via the Prog Select-button. The program numbers are called up from low to
high. You can invert the program selection by pressing and holding the Prog Select-button and pressing
the Mode Select-button.
This function is designed for bands etc.

6.5 Auto-Speed/Auto-Sound Mode

Spots run through all internal programs:
In this mode, all 48 programs of the LCD-8 can be run sound or speed-controlled.
You can manually adjust the individual channels via the channel faders, the dimmer fader and via the flash-
buttons.
1. Turn controller ON
2. Press Mode Select until Auto Speed/Auto Sound LED is illuminated. If this LED is flashing, the Speed-
mode is activated and if this LED is permanently illuminated, the sound-mode.
3. Adjust dimmer fader for total output
4. Adjust Speed fader or Audio fader until the spots react in the desired speed or to the music signal
5. Select the desired program via the Prog Select-button. The program numbers are called up from low to
high. You can invert the program selection by pressing and holding the Prog Select-button and pressing
the Mode Select-button.
This function is designed for discotheques, entertainers or party rooms.

6.6 Memory-function

Function: programmng
1. Select Memory via the MODE SELECT button.
2. Press and hold the PROG SELECT-button and Stand By until the display shows "PA". The display shows
"01". Now you can program the first step via the channelfaders and the master-fader ("DIMMER"). Save the
step with the PROG SELECT-button and the display shows "02". Now you can program step 2 etc.
The steps cannot be edited or deleted. You must program new steps, starting from step 1.
Function: call up the programs
You have different possibilities to call up the program.
Press and hold the buttons PROG SELECT and Stand By until the display shows"St". This means that you
can call the steps manually by pressing the PROG SELECT button.
Press and hold the buttons PROG SELECT and Stand By until the display shows"ASt". This means that the
steps are called sound-controlled. Make sure that the Audio-control is set to 100 %.
Press and hold the buttons PROG SELECT and Stand By until the display shows"AP". This means that the
steps are called with the speed adjusted via the Speed-control.
You can adjust the Fade Time with the FADE TIME-control. Dimmer is no longer activated.
Please note: after switching off, the controller "remembers" the last operation mode.
16/31 00042252.DOC, Version 1.7