Setup; Installation; Sound-Control; Connection With The Dimmerpacks - EuroLite LCD-8 Manual Del Usuario

Rear panel:
16) Audio input socket
17) Power supply socket
18) DMX output socket
19) Analog output socket

5. SETUP

5.1 Installation

Install the device on a plane surface or install it in rack.
This device is built for 483 mm racks (19"). This rack should be a double-door rack where front panel and
rear panel can be opened. The rack should be provided with a cooling fan. When mounting the device into
the rack, please make sure that there is enough space around the device so that the heated air can be
passed on. Steady overheating will damage your device. You can fix the device with four screws M6 in the
rack. If several devices are to be installed, make sure that you leave 1 unit (1 u) space between the devices.
Connect the connection cable of the power-unit with the DC IN-socket. Plug the power unit into your outlet.

5.2 Sound-control

The sound-control works via the built-in microphone or via the sound input socket.
For selecting the signal source:
When turning the unit on, press and hold the Prog Select-button and switch between E and I via the Mode-
Select-button.
Connect the sound-signal from the mixer (e.g. Master 2) with the RCA-socket on the rear panel (input
sensitivity 0.1 V - 1 V).

5.3 Connection with the dimmerpacks

DMX-512:
The wires must not come into contact with each other, otherwise
the fixtures will not work at all, or will not work properly.
Only use a stereo shielded cable and 3-pin XLR-plugs and connectors in order to connect the controller with
the fixture or one fixture with another.
Building a serial DMX-chain:
Connect the DMX-output of the LCD-8 with the DMX-input of the nearest dimmerpack. Always connect one
output with the input of the next fixture until all fixtures are connected.
14/31 00042252.DOC, Version 1.7