Customer Responsibilities - Craftsman CMXECXM301 Manual De Instrucciones

Tabla de contenido
Idiomas disponibles

Idiomas disponibles

MAINTENANCE
WARNING: To reduce the risk of serious personal
injury, turn unit off and disconnect it from power
source before making any adjustments or
removing/installing attachments or accessories.
An accidental start-up can cause injury.
WARNING: Risk of unsafe operation. Unit cycles
automatically when power is on. When performing
maintenance, you may be exposed to voltage
sources, compressed air, or moving parts. Personal
injuries can occur. Before performing any
maintenance or repair, disconnect power source
from the compressor and bleed off all air pressure.
To ensure efficient operation and longer life of the air
compressor outfit, a routine maintenance schedule should be
prepared and followed. The following routine maintenance
schedule is geared to an outfit in a normal working
environment operating on a daily basis. If necessary, the
schedule should be modified to suit the conditions under
which the compressor is used. The modifications will depend
upon the hours of operation and the working environment.
Compressor outfits in an extremely dirty and/or hostile
environment will require a greater frequency of all
maintenance checks.

Customer Responsibilities

Daily Weekly
Check safety valve
X
Drain Tank
X
Check Pump Oil Level
X
Inspect Air Filter
Change Oil Pump
X
Oil Leak Inspection
X
Inspect Drive Belt
Check Drive Belt
Tension
Check Pulley/
Flywheel Alignment
Check for Unusual
X
Noise/Vibration
X*
Check for Air Leaks
Clean Compressor
Exterior
***SEE TANK WARNING LABEL FOR DATE TO REMOVE TANK
FROM SERVICE***For more information, call our Customer
Care Center at 1-888-331-4569
*To check for air leaks apply a solution of soapy water around
joints. While compressor is pumping to pressure and after
pressure cuts out, look for air bubbles to form.
**the pump oil must be changed after the first 20 hours of
operation. Thereafter, when using full synthetic non-detergent
air compressor oil, change oil every 100 hours of operation or
once a year, whichever comes first.
+Perform more frequent in dusty or humid conditions.
NOTE: See Operation section for the location of controls.
9
ENGLISH
Monthly
1 Year or
Every
100 Hours
X+
X**
X
X
X
Tabla de contenido

Solución de problemas

loading

Tabla de contenido