Dyna-Glo DGP552SSN Manual Del Usuario página 14

ASSEMBLY INSTRUCTIONS
side burner valve and the side burner control
Assemble the ignition wire to the side burner
electrode.
Hardware Used
BB M4x12 Bolt
16. Disassemble two M4x10 bolts and two M4
washers that are pre-assembled on the side
is placed into the gas inlet tube of side burner.
the ignition wire to the side burner electrode.
WARNING: IT IS VERY IMPORTANT TO CHECK
AND ENSURE THAT EACH AND EVERY BURNER
IS FULLY ENGAGED WITH THE ADJACENT VALVE
ORIFICE BEFORE COMPLETING STEP 16.
FAILURE TO DO SO MAY
RESULT IN FIRE OR
EXPLOSION, POSSIBLY
CAUSING SERIOUS
INJURY OR DEATH. REFER TO MAINTENANCE
SECTION INSTRUCTIONS TO PROPERLY CHECK
THE ENGAGEMENT.
Incorrect
Incorrect
Correct
15
BB
x 2
16
14
G
H
2 washers
previously
disassembled
2 bolts previously
disassembled
D
E
F
E
F