VOX electronics MS-5008 Manual De Usuario página 7

Instruction for blender
Max operation duration per time should less than 30 second, and 3 minute rest time
must be maintained at two consecutive cycles.
1. To assemble the detachable shaft with the motor unit, turn the shaft anti-clockwise
direction until tightened. To disassemble, just turn in the adverse direction.
2. Simply plug the hand-held blender to power outlet.
3. Lower the hand-held blender into food. Then press and hold the low speed button
or high speed button to start operating.
4. To stop the hand-held blender by releasing the low speed button or high speed
button.
5.When blending banana, cut small piece, and place it into blending jar, then add
milk, the max quantify of banana can't exceed 200g，milk，300g, in every blending.
Instruction for chopper
Max operation duration per time should less than 15 second, and 3 minute rest time
must be maintained at two consecutive cycles.
1. Place the chopper bowl on a clean, level surface.
2. Assemble the stainless chopping blade into the chopper bowl, as shown in Fig.1.
3. Place food into the chopper bowl.
Note: remove the bone of the meat, cut small piece, then place the meat into bowl,
the max quantity of meat can't exceed 200g in every blending.
4. Attach the lid onto the chopper bowl, make sure the tuber on the inside wall of
bowl aligns with the groove of lid, then put down and press the lid and it locks into
position. (See Fig.2) The lid will spring up while you do not press it, you may
remove it at that time.
5. Insert the motor unit into the hole of the chopper lid, press the motor unit to lock.
The motor unit will spring up while you do not press it, you may remove it at that
time. (See Fig.3)
6. Lower the hand-held blender into food. Then press and hold the low speed button
or high speed button to start operating.
7. To stop the appliance by releasing the low speed button or high speed button of
the motor unit.
8. After finishing chopping, unplug the power outlet firstly, then remove the motor
unit from the chopper lid by turning it in anti-clockwise. Then, you can take up the
motor unit and lid cover.
Caution:
-To reduce the risk of injury, never place cutting blade on base without first putting
bowl properly in place.
- Be sure chopper lid is securely locked in place before operating appliance.
- During operating or after chopping, for safety, you shall disassemble the motor unit
from the chopper lid firstly, then remove the chopper lid. Never remove the chopper
lid with the motor unit in place.
5