Operation; Selecting The Flushing Programmes; Setting The Flushing Duration (S4); Setting The Interval (S5) - DURAVIT DuraStyle 280631 Serie Manual De Uso

2 short signal tones will sound and then service programme S5 will be selected.
> Within 4 seconds, hold the magnetic key in front of the right-hand sensor again.
2 short signal tones will sound to confirm the reset.
> Remove the magnetic key.
The factory settings are active.

5. Operation

5.1 Selecting the flushing programmes

Refer to page 2 for a diagram showing the signal sequence.
Selecting Standard (P1)
> Hold the magnetic key in front of the right-hand sensor.
Within approx. 3 seconds, several short signals will sound. Then 3 long signals will sound.
> Remove the magnetic key.
2 short signal tones will sound and the flushing programme P1 will be selected.
Selecting Hybrid (P2)
> Hold the magnetic key in front of the right-hand sensor.
Within approx. 3 seconds, several short signals will sound. Then 4 long signals will sound.
> Remove the magnetic key.
2 short signal tones will sound and the flushing programme P2 will be selected.

5.2 Setting the flushing duration (S4)

> Hold the magnetic key in front of the right-hand sensor.
Within approx. 3 seconds, several short signals will sound. Then 6 long signals will sound,
whereby a longer pause of approx. 6 seconds will occur between the 5th and 6th signal tone.
> Remove the magnetic key.
2 short signal tones will sound and then service programme S4 will be selected.
> Within 4 seconds, hold the magnetic key in front of the right-hand sensor again.
Flushing starts and, at the same time, a signal tone sounds at one-second intervals.
> Hold the magnetic key in front of the right-hand sensor until the desired flushing duration is
set. Do this for a minimum of 1 seconds and a maximum of 4 seconds.
> Remove the magnetic key.
2 short signal tones will sound to confirm the set flushing duration. Then the selected flushing
programme will be reactivated.

5.3 Setting the interval (S5)

Prerequisite: Flushing programme P2 is selected.
> Hold the magnetic key in front of the right-hand sensor.
Within approx. 3 seconds, several short signals will sound. Then 7 long signals will sound,
whereby a longer pause of approx. 6 seconds will occur after the 5th and 6th signal tone.
> Remove the magnetic key.
2 short signal tones will sound and then service programme S5 will be selected.
> Within 4 seconds, hold the magnetic key in front of the right-hand sensor again.
A signal sounds every second.
> Hold the magnetic key in front of the right-hand sensor until the desired interval is set. Do
this for a minimum of 1 second (10 uses) and a maximum of 5 seconds (50 uses).
> Remove the magnetic key.
2 short signals will sound to confirm the set interval. Then the selected flushing programme
will be reactivated.

6. Cleaning and care

In order to clean the electronic urinal, the flushing programme is deactivated. 2 service pro-
grammes are available for this (see chapter 3.6). Refer to page 2 for a diagram showing the signal
sequence.
19