Environmental Protection - Ratio TR1050NM Manual De Instrucciones

G
H1
H2
WORKING HINTS FOR
YOUR DRILL
1. Drilling masonry and concrete
Select the drill/impact action selector switch to
the "hammer symbol" position. Tungsten carbide
drill bits should always be used for drilling
masonry, concrete etc with a high speed.
2. Drilling steel
Select the drill/impact action selector switch to
the "drill symbol" position. HSS drill bits should
always be used for drilling steel with a lower
speed.
3. Screw driving
Select the drill/impact action selector switch to
the "drill symbol" position. Use a low speed to
drive in or remove screws.
4. Pilot holes
When drilling a large hole in tough material (i.e.
steel), we recommend drilling a small pilot hole
first before using a large drill bit.
5. Drilling tiles
Select the drill/impact action selector switch
to the "drill symbol" position to drill the tile.
When tile has been penetrated, switch over to
"hammer symbol" position.
6. Cool the motor
If your power tool becomes too hot, set the
speed to maximum and run no load for 2-3
minutes to cool the motor.
34
MAINTENANCE
1. Your power tool requires no additional
lubrication or maintenance. There are no
user serviceable parts in your power tool.
2. Never use water or chemical cleaners to
clean your power tool. Wipe clean with a dry
cloth.
3. Always store your power tool in a dry place.
4. Keep the motor ventilation slots clean.
5. If the supply cord is damaged, it must be
replaced by the manufacturer, its service
agent or similarly qualified persons in order
to avoid a hazard.
TROUBLESHOOTING
1. If your drill will not operate, check the power
at the mains plug.
2. If the drill is not cutting properly, check the
drill bit for sharpness, replace drill bit if worn.
Check that the drill is set to forward rotation
for normal use.
3. If a fault can not be rectified return the drill to
an authorized dealer for repair.
ENVIRONMENTAL
PROTECTION
Waste electrical products must not be
disposed of with household waste. Please
recycle where facilities exist. Check with
your local authorities or retailer for recycling
advice.