Intended Use - Ratio TR1050NM Manual De Instrucciones

OPERATING
INSTRUCTIONS
NOTE: Before using the tool, read the
instruction book carefully.

INTENDED USE

The machine is intended for impact drilling in
brick, concrete and stone as well as for drilling in
wood, metal and plastic.
1. AUXILIARY HANDLE (See Fig A)
For your personal safety we recommend using
the auxiliary handle at all times.
To fit the handle, loosen the bottom of the handle
anti-clockwise and slide the clamping loop over
the handle collar. Rotate the handle around the
handle collar until the handle is in the desired
position. Tighten fully. If you are right handed
fit the handle as shown in Fig A. If you are left
handed fit the handle the other way round.
Loosen
Tighten
A
2. INSTALLING THE DEPTH GAUGE(See Fig B)
The depth gauge can be used to set a constant
depth to drill. To use the depth gauge, loosen the
locking screw anti-clockwise. Insert the depth
Loosen
gauge through hole in handle. Slide the depth
Tighten
gauge to required depth and tighten the locking
A
screw by rotating the locking screw clockwise.
B
B
3. INSERTING A TOOL INTO CHUCK
C1
(See Fig C1 , C2)
32
2
1
First pull the locking sleeve (a) backward until
you hear a "click" sound. Then, while holding
the locking sleeve, rotate and loosen the front
section of the chuck to open the chuck jaws.
Insert the drill bit into the chuck jaws, and while
holding the locking sleeve, rotate and tighten the
front section in the opposite direction. Ensure
that the drill bit is in the center of the chuck jaws.
Finally, push the locking sleeve forward until you
hear a "click" sound. Your drill bit is now locked
in the chuck.
WARNING: Remove the plug from
the socket before carrying out any
adjustment, servicing or maintenance.