Garland SIOUX 1455 ZSL Manual De Instrucciones página 50

English
Mulching cut:
In this setting the mowed grass will be on the lawn,
but unlike the lateral discharge cutting setting, the
cut grass is crushed into small particles that are
deposited on the lawn thus generating an organic
fertilizer that provides nutrients and helps maintain
moisture. For this setting the bag and side deflector
must not be installed. The mulching plug should be
installed and the rear output cover and side cover
must be closed.
Place the mower in a corner of the lawn area to be
cut and set the desired cutting height.
Check that the bag is properly installed; make sure
that the blade is not in contact with any object, and
start the mower.
Walk on the grass to the rhythm of the mower.
Do not tilt the machine with the engine running
except in the case that you have to start cutting tall
grass, which is the only case in which you may raise
the front wheels slightly to facilitate entry of the
mower to the work area.
Note: If the grass is very high it will be difficult for
you to start the engine. If the grass is very high, you
should slightly raise the lawnmower's front wheels,
forcibly pushing down with the handle, and start
your lawnmower in this position. Once the engine
has acquired the normal engine speed slowly lower
the mower wheels while the machine starts to cut.
Alternatively, if next to the lawn area there is a flat
surface free of objects and without grass (Earth,
screed, concrete), start the lawnmower in the clear
area and entering the grass area by slightly lifting the
front wheels of the lawnmower.
If the engine's rotation speed goes into excess or
it stops, it means that the grass is too high for the
lawnmower's cutting capacity and forcing this can be
harmful to the machine. In this case, make a first cut
at the machine's maximum height and then a second
cut at the desired height.
7.4. EMPTYING THE BAG
Empty the lawnmower's bag as soon as you notice
it is full. You will notice that the bag is full because
the mower will stop picking up the cut grass as well,
leaving many remains on the ground.
Whenever you are going to empty the bag, turn off
the engine and check that the blade has stopped
before removing the bag.
1. Lift the lid from the rear exit.
2. Lift the sack.
3. Remove the bag back.
50/184