Bosch GSA 18 VE Professional Manual Original página 18

OBJ_BUCH-257-002.book Page 18 Tuesday, November 11, 2008 8:38 AM
18 | English
Technical Data
Sabre saw
Article number
Rated voltage
Stroke rate at
no load n
0
Tool holder
Stroke rate control
Stroke
Weight according to
EPTA-Procedure
01/2003
Please observe the article number on the type plate of
your machine. The trade names of the individual ma-
chines may vary.
Noise/Vibration Information
Measured values determined according to
EN 60745.
Typically the A-weighted noise levels of the
product are: Sound pressure level 90 dB(A);
Sound power level 101 dB(A). Uncertainty
K =3 dB.
Wear hearing protection!
Vibration total values (triax vector sum) deter-
mined according to EN 60745:
Cutting wood: Vibration emission value
2
a =19 m/s , Uncertainty K=1 m/s
h
The vibration emission level given in this infor-
mation sheet has been measured in accordance
with a standardised test given in EN 60745 and
may be used to compare one tool with another.
It may be used for a preliminary assessment of
exposure.
The declared vibration emission level repre-
sents the main applications of the tool. However
if the tool is used for different applications, with
different accessories or poorly maintained, the
vibration emission may differ. This may signifi-
cantly increase the exposure level over the total
working period.
An estimation of the level of exposure to vibra-
tion should also take into account the times
2 609 932 557 | (11.11.08)
when the tool is switched off or when it is run-
ning but not actually doing the job. This may sig-
nificantly reduce the exposure level over the to-
GSA 18 VE
tal working period.
Professional
Identify additional safety measures to protect
3 601 F4G 0..
the operator from the effects of vibration such
as: maintain the tool and the accessories, keep
V= 18
the hands warm, organisation of work patterns.
-1 min 0 – 2300
Declaration of Conformity
SDS
We declare under our sole responsibility that
the product described under "Technical Data" is
in conformity with the following standards or
mm 25
standardization documents: EN 60745 accord-
ing to the provisions of the directives
2004/108/EC, 98/37/EC (until 28 Dec 2009),
kg 3.9
2006/42/EC (from 29 Dec 2009).
Technical file at:
Robert Bosch GmbH, PT/ESC,
D-70745 Leinfelden-Echterdingen
Dr. Egbert Schneider
Senior Vice President
Engineering
Robert Bosch GmbH, Power Tools Division
D-70745 Leinfelden-Echterdingen
30.10.2008
Assembly
2
.
Battery Charging
A battery that is new or has not been used for a
longer period does not develop its full capacity
until after approx. 5 charging/discharging cy-
cles.
To remove the battery 8 press the unlocking but-
tons 7 and pull out the battery downwards. Do
not exert any force.
The battery is equipped with a NTC temperature
control which allows charging only within a tem-
perature range of between 0 °C and 45 °C. A
long battery service life is achieved in this man-
ner.
Dr. Eckerhard Strötgen
Head of Product
Certification
Bosch Power Tools