Nexgrill FORTRESS 2.0 Manual Del Propietário página 12

LEAK TEST
WARNING:
CHECK ALL GAS SUPPLY FITTINGS FOR LEAKS BEFORE EACH USE. DO NOT USE THE GRILL UNTIL ALL
CONNECTIONS HAVE BEEN CHECKED AND DO NOT LEAK. DO NOT SMOKE WHILE LEAK-TESTING. NEVER
LEAK-TEST WITH AN OPEN FLAME.
GENERAL
Although gas connections on the grill are leak-tested prior to shipment, a complete leak test must be performed at the
installation site. Before each use, check all gas connections for leaks using the procedures listed below. If the smell of gas is
detected at any time, turn off gas supply and immediately check the entire system for leaks.
BEFORE TESTING
Make sure all packing materials have been removed from the grill, including the burner tie-down straps.
1
3
11
50 %
50 %
2
4
STEP 1
CREATE THE SOAPY WATER
Prepare a 50/50 solution of water and ammonia-free dish
detergent, to be applied using a spray bottle or brush.
STEP 2
CONNECTING THE REGULATOR TO THE LPG CYLINDER
Fully close the cylinder valve on the LPG cylinder and make
sure the burner valves are in the "OFF" () position prior to
connecting the regulator.
Inspect the valve connections, burner ports, and the regulator
assembly.
Some regulators push ON to connect and pull OFF to disconnect,
whereas others have a nut that either have a left-hand or a right-
hand thread that connects to the cylinder valve. Identify your
regulator type and follow the connection instructions specific
to that regulator.
Connect by Turning Clockwise (1)
Screw regulator onto cylinder by turning the connecting nut
clockwise.
Connect by Turning Anti-Clockwise (2)
Screw regulator onto cylinder by turning the connecting nut
anti-clockwise.
Connect by Turning Lever/Snapping into Position (3)
Turn regulator lever clockwise to the OFF position. Push regulator
down on cylinder valve until your hear the audible 'click'. Check
that the regulator is fully locked and in place by gently pulling
upwards. If regulator disengages, repeat procedure.
Connect by Sliding Collar (4)
Make sure regulator lever is in the off position. Slide the
retaining ring of the regulator up. Push the regulator down
onto the cylinder valve and maintain downward pressure
on the regulator. Slide retaining ring down to lock regulator
onto cylinder valve. Check that the regulator is secured. If the
regulator disengages, repeat procedure.
Note: If your grill is not equipped with a hose and regulator
assembly, please refer to the "European Gas Pressures and
Specifications" table to clarify the regulator gas pressure and
orifice size required.