GE PS920 Manual De Instrucciones página 32

Troubleshooting tips (Cont.) ... Before you call for service
Problem
Power outage, clock
flashes
"Burning" or "oily" odor
emitting from the vent
Strong odor
Fan noise
My oven door glass
appears to be "tinted"
or have a "rainbow"
color. Is this defective?
Sometimes the oven
takes longer to preheat
to the same temperature
Display flashes
Unable to get the
display to show "SF"
Control signals after
entering cooking time
or start time
Oven racks are difficult
to slide
Steam from the vent
Drawer does not slide
smoothly or drags
Warming drawer will not
work
Excessive condensation
in the drawer
Food dries out in the
warming drawer
Water remaining on
oven floor after Steam
Clean cycle
"Probe" appears in
the display (on some
models)
32
Possible Cause
Power outage or surge
This is normal in a new oven and will
disappear in time.
An odor from the insulation around
the inside of the oven is normal for the
first few times the oven is used.
A convection fan may automatically
turn on and off.
No. The inner oven glass is coated with
a heat barrier to reflect the heat back
into the oven to prevent heat loss and
keep the outer door cool while baking.
Cookware or food in oven.
Number of racks in oven.
Different cooking modes.
Power failure.
Oven control pads were not touched
properly.
You forgot to enter a bake temperature
or cleaning time.
The shiny, silver-colored racks were
cleaned in a self-clean cycle.
When using the ovens, it is normal to
see steam coming out of the oven vents.
As the number of racks or amount
of food being cooked increases, the
amount of visible steam will increase.
The drawer is out of alignment.
Drawer is over-loaded or load is
unbalanced.
A fuse in your home may be blown or
the circuit breaker tripped.
Controls improperly set.
Liquid in drawer.
Uncovered foods.
Temperature setting too high.
Moisture escaping.
Drawer not fully closed.
This is normal.
This is reminding you to enter a probe
temperature after plugging in the probe.
What To Do
Reset the clock. If the oven was in use, you must reset it by
pressing the Cancel/Off pad, setting the clock and resetting
any cooking function.
To speed the process, set a self-clean cycle for a minimum
of 3 hours. See the Cleaning the Oven section.
This is temporary and will go away after several uses or a
self-clean cycle.
This is normal. The fan is designed to operate intermittently to
maximize cooking evenness. The convection fan will operate
during preheat of the bake cycle. The fan will turn off after the
oven is heated to the set temperature. This is normal.
this tint or rainbow color.
The cookware or food in the oven will cause the oven to take
longer to preheat. Remove items to reduce preheat time.
Adding more racks to the oven will cause the oven to take
longer to preheat. Remove some racks.
The different cooking modes use different preheat methods
to heat the oven for the specific cooking mode. Some
modes will take longer than others (i.e. convection bake).
Reset the clock.
The Broil HI/LO and Bake pads must be touched at the
same time and held for 3 seconds.
Touch the Bake pad and desired temperature or the Self
clean pad and desired clean time.
Apply a small amount of vegetable oil to a paper towel and
wipe the edges of the oven racks with the paper towel. Do
not spray with Pam ® or other lubricant sprays.
This is normal.
Fully extend the drawer and push it all the way in See the
Care and cleaning of the range section.
Reduce weight. Redistribute drawer contents.
Replace the fuse or reset the circuit breaker.
Remove liquid.
Cover food with lid or aluminum foil.
Reduce temperature setting.
Cover food with lid or aluminum foil.
Push drawer in until latch engages.
Remove any remaining water with a dry cloth or sponge.
Enter a probe temperature.
49-80694-1