Tabla de contenido
Idiomas disponibles
Idiomas disponibles
1. Remove mounting kits shipped with liftgate. Refer to
kits on Sheets 1 through 5. Verify mounting brackets
are the correct brackets for this installation.
`
Liftgate will not stand upright without the shipping angles. Before removing the
angles, make sure Liftgate is supported with forklift or pallet jack. Injury & prop-
erty damage could result if Liftgate falls over.
2. Support Liftgate on shipping
pallet with forklift or pallet
jack. Unbolt and remove
cover from the main frame
housing. Then, unbolt ship-
ping angle from each col-
umn on the Liftgate (FIG.
7-1). Save shipping angles
to use for lower mounting
brackets.
3. Unbolt bracket plates
from bottom of main
frame housing (FIG. 7-2).
Save the plates to use for
lower mounting brackets.
LIFT CORPORATION Sht. 7 of 58 DSG#
PREPARE LIFTGATE
!
5/16" HEX NUT,
5/16" FLAT WASHERS
(3 PLACES)
BRACKET PLATE
(2 PLACES)
3/8" FLAT WASHER
(2 PLACES)
CAUTION
3/8"-16 BOLT,
3/8" LOCK WASHER,
LH COLUMN
COVER
REMOVING SHIPPING ANGLES
3/8"-16 BOLT
(2 PLACES)
REMOVING BRACKET PLATES
(PLATFORM NOT SHOWN)
FIG. 7-2
M-15-25
Rev. E Date: 08/13/19
3/8"-16 NUT
(4 PLACES)
SPACER
(2 PLACES)
RH COLUMN
FIG. 7-1
ANGLE
(2 PLACES)
Tabla de contenido
