THERMEx VALENCE LAMP Instrucciones De Uso página 47

B 528234101217092018
When using the remote control for the first time, the accompanying battery must be inserted first:
• Unpack the battery.
• Remove the battery holder from the base of the remote control by releasing the small clips in the base of the remote control.
• Insert the battery. NOTE: take care to position the battery correctly.
• Push the battery holder back into place.
• The remote control is now ready for use.
EXTRAcTION
The motor is activated by pressing the (+) button. The motor always starts at speed 1. The motor speed is increased by pressing on the (+) button
and reduced by pressing on the (-) button. The indicator for speed shows which speed the motor is running at.
The motor is switched off by pressing the (-) button until the indicator for speed reads 0.
LIGHT
The light on the hood is turned on and off by pressing on the on/off light button.
AFTER-RUNNING
After-running means that the motor will stop automatically a given number of minutes after this function has been activated. After-running can
run from 10 to 90 minutes, and runs at the selected speed.
After-running is activated in the following way:
• Switch on the hood to the desired speed.
• Press on the on/off after-run button.
• The indicator will now flash with the number 0.
• Use the (+) and (-) buttons to adjust the time for which the after-run function should run. If '1' is selected, the after-run will run for 10 min-
utes, if '2' is selected, after-run runs for 20 minutes, etc. The after-run function can be set for a maximum of 90 minutes.
• confirm the selected time by pressing the on/off after-run button.
• The indicator of speed will now display the speed at which the motor runs and the panel indicator will flash to indicate the after-run function
is activated.
The after-run function can always be cancelled by pressing on the on/off after-run button or by switching off the hood. If the after-run function
is cancelled, then the panel indicator will stop flashing.
Should it be desirable to regulate the speed of the after-run function during activation, it is done using the (+) and (-) buttons until the desired
speed has been reached. The panel indicator will continue to flash to indicate that the after-run function is activated.
THERMEX VALENcE LAMP 47