Ryobi TS1143L Manual Del Operador página 25

 Grasp the stock firmly with one hand and secure it against
the fence. Use the work clamp, C-clamp, or other suitable
clamp to secure the workpiece when possible.
 Before turning on the saw, perform a dry run of the cutting
operation just to make sure that no problems will occur
when the cut is made.
 Grasp the saw handle firmly. Depress the switch lock
with thumb then squeeze the switch trigger. Allow several
seconds for the blade to reach maximum speed.
 Slowly lower the blade into and through the workpiece.
 Release the switch trigger and allow the saw blade to stop
rotating before raising the blade out of the workpiece.
Wait until the blade stops turning before removing the
workpiece from miter table.
TO SUPPORT LONG WORKPIECES
See Figure 30.
Long workpieces need extra supports. Supports, roller stand,
or work surface level with the saw table should be placed
along the workpiece so it does not sag. The support should let
the workpiece lay flat on the base of the saw and work table
during the cutting operation. Use the work clamp, C-clamp, or
other suitable clamp to secure the workpiece when possible.
OPERATION
LONG
WORKPIECE
25 - English
WORKPIECE
SUPPORTS
Fig. 30