GreenWorks GPW 1602 Manual Del Operador página 12

ASSEMBLING THE PRESSURE WASHER GUN
■ Insert the male end (A) of the wand into the female bayonet outlet (B) firmly.
■ While pushing in the wand firmly, turn clockwise until tabs lock into place to ensure a leak-free
connection.
(See Figure 3-2.)
CONNECTING HIGH PRESSURE HOSE TO TRIGGER HANdLE
■ Connect the high pressure hose to the pressure washer gun assembly by turning the fitting clockwise.
Ensure the fitting is fully tightened to the pressure washer gun.
NOTE: For easier installation of the hose to the unit or trigger it is suggested to add pressure washer or
dish detergent to the rubber seal at each end of the hose. This will allow for easier installation and a snug
fit.
ASSEMBLY
A
B
Fig. 3-1
Inlet Coupler
EN - 12
(See Figure 3-1.)
(See Figure 4.)
Collar
High Pressure Hose
Fig. 4
Fig. 3-2