Assembly And Installation Manual; B1 Minidue Filtro Installation - Acqua Brevetti MiniDUE FILTRO Manual De Instrucciones

ASSEMBLY AND INSTALLATION MANUAL

B1 MiniDUE FILTRO INSTALLATION

B1.1 Before the installation
Attention! Before installation please check the water supplied to the equipment fulfils the requirements of
European drinking water directives (Directive 98/83/CE) Check for the compliance of the waterworks and
the installation of the equipment to local regulations. The manufacturer disclaims all responsibility for damage or
injury caused by improper installation of the equipment and/or the installation of the equipment in a waterworks not
compliant with local regulations.
MiniDUE FILTRO is not equipped, by standard, with any flooding-control system or other devices able to detect,
control or alarm in case of runaway water losses. In case, consider, apart, an adequate anti flooding device.
Do not install MiniDUE FILTRO downstream of boilers or in devices involving the transit, inside the pump, of water
at higher than 30°C temperature. Install MiniDUE FILTRO upstream of boilers or devices to protect.
MiniDUE FILTRO cannot be used to treat closed loop water, closed loop heating systems, process water, sewer
water or any other applications not cited in this manual.
Before installing MiniDUE FILTRO or any other equipment for polyphosphates dosage upstream of solar boilers or
water storage tank where temperature could rise, for long times, above 60 °C please contact Acqua Brevetti Srl.
echnical office. The permanence of AcquaSIL 2/15
temperature may imply the partial loss of anti scaling effectiveness.
B1.2 Requirements of the installation place
MiniDUE FILTRO must be installed indoors in a dry and clean place, protected from frost, exposure to sunlight,
moisture, rain, snow and hail. Do not install MiniDUE FILTRO in wells, near drains, or in smelly or not cleaned
places. Do not install where chemical vapours or gas and fumes may be present. Avoid installation in tight spaces
which cannot allow easy ordinary and extraordinary maintenance. Room temperature (min./max), °C:
B1.3 Laws, Regulations and Standards
The installation of MiniDUE FILTRO must be performed in compliance with local laws, regulations and standards.
B1.4 Instruction for installation
The installation must be perform in accordance with best practice, in line with all the current legislation and the rating
data.
Before installing the pump make sure that the plant fits with the laws or regulations or local recommendations
produced by the office in charge.
Before installing the pump clean pipes and appliances installed upstream of the pump to eliminate foreign bodies which
can cause the malfunction of the pump. If the level of cleanliness in the plant is not adequate you should sanitize the
plant and the possible storage tanks before the installation of MiniDUE FILTRO. The pump should not be installed
between the boiler and safety devices.
The water distribution system should endowed with non-return devices. The hydraulic system implemented to install
devices connected to the water distribution system must be provided with a system able to ensure the non return of
the treated water in the distribution system. The equipment should be endowed with a manual or automatic by-pass
valve system in order to allow the withdrawal of non treated water interrupting the flow of treated water.
MAN 117
MiniDUE FILTRO - ENGLISH
®
and, at large, of all the polyphosphates in storages at high
5/40.
PAG.E-10