Loosening The Harness - juju Safe Rider Manual De Usuario

To release your child seat following the above instructions in reverse order.
Ensure that each part ofthe belt is tightened as possible.
Make sure all the belts' position is right and they has not become twisted. Also check
that the cover is not impeding the movement or fit of the belt webbing in any way.
When installing the child car seat(Group I), In no way should you use the head belt
guide (group II III ) in the head rest.

4.3. Loosening the harness

The harness is slackened by pressing the lever
(under the seat cover) on the front ofthe seat. Press
down on the label marked"Press" as you grip the
two shoulder straps with your other hand. Pull the
shoulder straps towards you to loosen the harness.
4.4. Securing the child with the harness
Firstly, adjust the shoulder belts height(see point 4.3 ), proceed as follows:
•
Loosen the harness, open the buckle and place them
down sideways.
•
Seat your child in the child car seat, place both
shoulder belts over your child's shoulders.
•
Fasten the buckle(see point 4.4.1).
•
Pull the shoulder straps upwards to remove the slack
from the lap sections of the harness then pull the
adjuster strap until the harness is fully tightened.
•
The harness should be adjusted as tightly as possible
without causing discomfort to your child.
•
A loose harness can be dangerous. Check the harness adjustment and tighten
each time the child is placed in the seat.
Ensure that any lap strap is worn low down, so that the pelvis is firmly engaged,
the belt is not twisted.
Page 11