Care Instructions - juju Safe Rider Manual De Usuario

5. 3 Securing the child car seat with vehicle's belt
The vehicle's 3—point belt system may only be used to buckle up children of the
age groups II and lll(15kg-36kg).
The harness system must be removed from the seat (see point 5.1) when used for
these age groups 15kg—36kg.
•
Step 1: Place the child safety seat on the vehicle's seat ensuring it is firmly
pressed against the car seat backrest(Fig. 5.3.1).
• Step 2: Seat your child in the child car seat (Fig. 5.3.2).
•
Step 3: Pull out the 3-point vehicle belt and place the lap belt on the opposite
side of the buckle under the arm rest.(make sure that the diagonal belts and
the lap belt on the buckle side are under the armrest) The lap strap should be
worn low down, so that the pelvis is firmly engaged and the straps should not
be twisted.
And allow it to the buckle in place. You will hear "click"(Fig. 5.3.3).
• Step 4: Place the diagonal belt goes through the Head belt guide on the side
ofthe headrest. Make sure that the belt is not twisted.
Tightenthe adult belts in the direction as picture shows(Fig. 5.3.3) and the
diagonal shoulder belt in the direction of the automatic roll-up as
possible(Fig.5.3.4).
The satisfactory position of the adult safety-belt buckle relative to the child
car seat is as the Fig 5.3.5. You can contact the child car seat manufacturer if
in doubt about this point.

6. Care instructions

6.1. Removing / replacing the cover
•
Remove the belt system as described in point 5.1.
•
Press the backrest so far back so that it rests flat on the floor.
•
Now you can remove the backrest.
•
You can remove the coverfrom the head rest.
•
Loosen the elastic on the backrest, you can remove the cover from the
backrest.
Page 13