GE AKL05 Manual Del Propietario E Instrucciones De Instalación página 5

When the air conditioner is turned on, it will
automatically start in the setting last used,
except the timer will be cancelled if it was set.
COOL Mode
Use the COOL mode with HIGH, MED or LOW fan
for cooling. Use the Increase v / Decrease w pads
to set the desired temperature between 60°F and
90°F in 2°F increments (or between 16°C and
31°C in 1°C increments if the control has been
set to use Celsius).
A thermostat is used to maintain the room
temperature. The compressor will cycle on and off
to keep the room at the set level of comfort. Set the
thermostat at a lower number and the indoor air
will become cooler. Set the thermostat at a higher
number and the indoor air will become warmer.
NOTE: If the air conditioner is off and is then turned on while
set to COOL, it will take approximately 3 minutes for the
compressor to start and cooling to begin.
FAN Mode
Use the FAN at HIGH, MED or LOW to provide
air circulation and filtering without cooling.
Since fan only settings do not provide cooling,
a temperature setting will not be displayed.
Vent Control
The vent control is located on the inside of the
air louvers at the bottom of the vent.
When set at CLOSE, only the air inside the room
will be circulated and conditioned. When set at
OPEN, some inside air is exhausted outside.
Air Direction
Up and Down
Fingertip pressure on the horizontal louvers
adjusts the air direction up or down.
Lights in the display or beside the touch pads
on the air conditioner control panel indicate the
selected settings.
Cooling Descriptions
For Normal Cooling—Select the COOL mode and
HIGH or MED fan with a middle set temperature.
For Maximum Cooling—Select the COOL mode
and HIGH fan with a lower set temperature.
For Quieter & Nighttime Cooling—Select the
COOL mode and LOW fan with a middle set
temperature.
NOTE: If you switch from a COOL setting to OFF or to
a fan setting, wait at least 3 minutes before switching back
to a COOL setting.
Fahrenheit or Celsius
Your control is set to use and display Fahrenheit temperature
selections, but you may change it to use and display Celsius
selections.
Press and hold the Increase v / Decrease w pads
at the same time to switch to ˚C or ˚F as desired.
Vent control
lever
To open the vent.
Side-to-Side
The side-to-side air direction is adjusted by moving
the air direction lever to the left or right.
www.GEAppliances.com
Vent control
lever
To close the vent.
Air direction
lever
5