GE AKL05 Manual Del Propietario E Instrucciones De Instalación página 15

8
Install the Case in the Window
Carefully position the case in the window so
A
that the bottom mounting rail is nested against
the window stool.
Center the case and lower the window behind
B
the top mounting rail.
Secure the bottom mounting rail of the case to
C
the window stool using 4 Type B screws.
Type B
screws
Loosely thread a
D
leveling bolt into
a support
bracket.
Position the support brackets near the
E
outermost point on the sill. From inside the
case, attach the support bracket to the case
bottom flange using 2 Type C screws.
Support
Leveling
bracket
bolt
Type C screws
Support
bracket
Repeat steps D and E to install the second
F
support on the other side of the case.
Adjust the leveling bolts against the sill so that
G
the supports had a slight tilt to the outside. Use
a level; about 1/2 bubble will be the correct
slant to the outside. After leveling is done,
tighten the leveling bolt nut.
NOTE: Use a steel washer between the leveling
bolts and the sill if the sill is weak.
Extend the left and right accordion panels to
H
the vertical window sashes. Drill 1/8" pilot
holes and attach the top corners with 2 Type B
screws. Use an accordion panel clamp on each
lower corner to trap the panels. Drill 1/8" pilot
holes and attach the panel clamps with 2 Type
B screws.
NOTE: Seal any openings around the case or
accordion panels with sealer or foam gaskets.
Top mounting rail
Type B
screw
Panel clamp and
Type B screw
1/2 bubble slant
to outside
Leveling bolt
Type B
screw
Panel clamp and
Type B screw
15