Urrea LI920A Manual De Usuario Y Garantía página 15

NOTE: The Impact Wrench will not run unless
the direction of rotation selector is engaged
fully to the left or right.
CAUTION:
•Always be sure that the tool is switched off
and the battery cartridge is removed before
adjusting or checking function on the tool.
• Always switch off the tool before installation
or removal of the battery cartridge.
• To remove the battery cartridge, withdraw it
from the tool while sliding the button on the
front of the cartridge.
• To insert the battery cartridge, align the
tongue on the battery cartridge with the
groove in the housing and slip it into place. Al-
ways insert it all the way until it locks in place
with a little click.
• Do not use force when inserting the battery
cartridge. If the cartridge does not slide in eas-
ily, it is not being inserted correctly.
With the Wrench held in normal operating po-
sition:
1. Position the direction-of-rotation selector to
the left of the tool for forward rotation.
2. Position the direction-of-rotation selector to
the right of the tool for reverse rotation.
3. Setting the switch in the OFF (center lock)
position helps reduce the possibility of acciden-
tal starting when not in use.
CAUTION: To prevent gear damage, always
allow the Impact Wrench to come to a com-
plete stop before changing the direction of
rotation.
SWITCHING ON AND OFF
Hold the tool firmly to control the twisting of
the tool.
To prolong the life of the tool never overload
it. Start the tool by squeezing the variable
speed trigger switch. Release the trigger to
stop the tool.
This tool has a variable speed switch that de-
livers higher speed and torque with increased
trigger pressure. Speed is controlled by the
amount of switch trigger depression.
NOTE: It is recommended to use the variable
speed feature for a short time only. Do not
continuously operate the tool at different
speeds. It may damage the switch.
E N G L I S H •
LED WORK LIGHT
CAUTION: Do not look in the light or see
the source of light directly. Pull the switch
trigger to light up the lamp. The lamp keeps
on lighting while the switch trigger is being
pulled.
Your tool has a LED
work light will come
on when the trigger
switch is depressed.
The LED work light
will turn off when the
trigger switch is re-
leased.
This provides additional lighting on the surface
of the workpiece for operation in lower-light
areas.
INSTALLING AND REMOVING SOCKET
CAUTION: Make sure that the tool is on OFF
position and the battery is removed when work-
ing on it.
WARNING: Do not use regular socket wrench
type sockets; use only those sockets designed
for impact wrenches. Impact wrench sockets
are black in color, specially hardened, and de-
signed to not strip the comers off the nuts and
bolts you will be driving. Sockets not designed
for impact wrenches could break and result in
personal injury. Inspect sockets prior to use to
ensure that they have no cracks or other visible
damage.
INSTALLING OR REMOVING SOCKET
1. For socket without
O-ring and pin to in-
stall the socket, push
it onto the anvil of
the tool until it locks
into place. To remove
the socket, simply pull
it off.
2. For socket with O-
ring and pin. Move
the O-ring out of the
groove in the socket
and remove the pin
from the socket.
Fit the socket onto the anvil of the tool so that
the hole in the socket is aligned with the hole
in the anvil. Insert the pin through the hole in
U se r's m a n ua l
15