Cebora SYNSTAR 330 TS Manual De Instrucciones página 26

kept as long as the welding torch trigger is pressed again.
When the torch trigger is pressed again, the welding cur-
rent will connect to the crater filling current and it will be
maintained until the torch trigger is released.
To adjust the values of the Start current, of the connec-
tion time and of the crater filling current enter the Main
Menu with key F MENU and enter the process parame-
ters menu.
Turn knob 2 to select the parameter, press it to enter the
regulation screen and turn it to adjust the value.
Press the key DEF to reset the factory set parameters.
D
Inductance.
0.0
The adjustment can vary from -9.9 to +9.9. Zero is the
number set by the factory: if the number is negative, the
impedance decreases and the arc becomes harder; if in-
creased, it becomes softer.
To enter the function select it with your finger. To adjust
the value just turn the knob 2.
E
Arc Correction.
0.0
To modify the arc length select it with your finger. To ad-
just this value just turn the knob 2.
F
Menu.
MENU
To use this function select it with your finger.
By selecting it you enter the Main Menu.
26
SELECTION OF THE WELDING PROCESS
Process
MIG, TIG OR MMA.
After having selected the MIG
knob 2 you can select the arc transfer type: MIG Pulse,
MIG Short and MIG Manual.
To confirm the selection press knob 2 or the key
SELECTION OF THE WIRE TYPE, DIAME-
Material
TER AND WELDING GAS.
To confirm the selection press knob 2 or the key
Parameters PROCESS PARAMETERS SELECTION.
• Arc length correction.
Turn knob 2 to select the parameter and confirm the
selection by pressing the same knob.
The value is adjusted by turning the knob 2.
To confirm the selection press knob 2 or the key
Press the key DEF to reset the factory set parameters.
• Inductance Correction.
Turn knob 2 to select the parameter and confirm the
selection by pressing the same knob.
, welding process with
.
.
.